Unknown Printer

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Sometimes a paper jam error persists even though there is no jammed paper (false paper jam). Reset the printer, which might clear a false paper jam error, and then try to print again. With the printer turned on, disconnect the power cord from the printer. Unplug the power cord from the power source.
Paper Handling

Reseat the paper currently loaded into your copier`s paper trays. Frequent paper jams often indicate a problem with how you loaded the paper into the tray. Sometimes simply removing the paper stack and reloading it into the tray can resolve the problem.

It could be that the paper you are trying to print on is damp. The paper could be of low quality or not the type designed to be used with your specific printer. A printer jam can also occur when you load the paper incorrectly, or when there is dust and static present on the paper.
The following are the top reasons why paper jams occur:

incorrect paper settings in the tray and/or the print driver. paper loaded incorrectly and/or paper edge guides not adjusted properly in the tray. humidity and/or paper condition and storage. Use a new ream of paper.

Do a hard reset on your printer. To do this you just need to turn off your printer, unplug for a few minutes and then plug the printer again. If that still doesn`t work, try turning the printer and your computer off, and then start it back up again. Try uninstalling and then reinstalling your printer driver.
Slide the paper all the way into the printer. The leading edge of the paper will stop at the Paper Drive Roller. Locate the Paper Sensor/OOPs sensor on the right side of the paper path. It can be seen from the top of the printer with the Top Cover open and has red, black, and blue wires attached to it.
Contrary to its name, there is nothing supernatural or spooky about a ghost jam. Instead, ghost jamming refers to an issue whereby the copier reports a paper jam even though there is no paper being physically jammed within the copier. Such an occurrence is also known as a fake jam or a false jam.
It`s important to replace the drum promptly when it`s low to avoid any further damage to the printer and to maintain optimal print quality. A bad drum may cause paper jams because it can cause the toner to be unevenly distributed on the paper, leading to jams or misfeeds.
Worn or dirty rollers can decrease friction and increase jams. Check the rollers for wear and gently clean them with a mild soap solution. If the paper is fed into the equipment at an angle or skewed in some way, you can end up with crooked folds or paper jams.
Dust, dirt, or debris: Not cleaning the HP Printer can also result in a paper jam error. So, if you find that no paper is stuck but a paper jam error showing, you must check for the dirt or dust on the device.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :
Unknown Printer

Paper Jam error but no paper jam
ANSWER : Obviously you didn’t get all the paper cleared out. There is a small scrap in the paper path causing the jam when the paper hits it. You can try clearing it out by inserting something stiff like a piece of file folder from the back of the printer into the paper path and pushing the offending piece out that way.

Read Full Q/A … :
Unknown Printer

Canon mx410 Paper jam message, but no paper jam?!
ANSWER : I have exactly the same problem, no answers 😳

Read Full Q/A … :
Unknown Printer

Paper Jam and carriage jam code when nothing is jammed
ANSWER : Did you try cleaning the encoder strip that runs through the cartridge assy.? Use Window Cleaner on a paper towel. Also, check inside on the right. I’ve seen a lot of times where there is a folded up scrap of paper that stops the carriage from going all the way to the right.

Read Full Q/A … :
Unknown Printer

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :
Unknown Printer

Paper jam in tray 2 (but no paper pulled from tray) also M476DN models
ANSWER : Isopropyl alcohol is not recommended for rubber rollers. It dries out the rubber and hasten it’s cracking and breaking. It will do nothing to restore the grip. Those rollers are really hard to replace. It would be easy if that dumbass secondary menu really worked. None of the techs I’ve spoke to ever got into it. Everyone I know sends a print job and listens for the roller to rotate into position where you can pull it off.

Read Full Q/A … :
Unknown Printer

Phaser Jams every time code: 0,006.74
ANSWER : http://www.support.xerox.com/support/phaser-8560mfp/support/enus.html

Read Full Q/A … :
Unknown Printer

Keep getting a paper jam message. There is no jam.
ANSWER : You can quit wondering. Parts are unavailable. I’ve seen posts where people have 3D printed the parts or machined them out of metal.

Read Full Q/A … :
Unknown Printer