Xerox Phaser 8400 Error codes

It means there is an incorrect parameter in the paper size. This happens mostly with the wrong print driver in use, or when an application overrides the driver. So make sure it is the right print driver, and make sure that the Application is not set to an odd size.

061-329 – ROS Connect Failure Black

The connection between the ROS LD and the MCU PWB failed.

Fault Code 012-238: Staple Center Position Sensor Off Fail-D2.

Fault Code 62-476-00, 362.476. 00: Scan Carriage Home Sensor was Not Cleared or Actuated in Time.

Fault Code 060-310: Warm Up Failure.

Fault Code 099-396, 099-397, 099-398, 099-399: Fuser Thermal Error. Power the Printer Off, Wait 10 Seconds, Power the Printer On. If the problem persists, contact Support for additional assistance.

Fault Code 062-380: Insufficient Lamp Brightness was Detected When Performing AGC. Clean the scanner about once a month, when anything is spilled on it, or when debris or dust collect on any of the surfaces. Keep the feed rollers clean to ensure the best possible copies and scans.

Fault Code 042-313: Fan Motor Failure.

Power off/on. Refer to Printer With Integrated Fiery Controller: Perform the Power Off / On Sequence for the Printer and Print Server. If the problem persists, contact Support for additional assistance.

Fault Code 377-900: Registration Sensor Static Jam.

Fault Code “305-958: SPDH Lift Home Sensor Failure” occurs when the input tray fails to return to the home position. Note: A “Lift Home Sensor” error may be caused by the Feed Roller at the entrance of the Document Handler being out of position or jammed with an obstruction.

This fault indicates a fault in the interface decurler. Restart the press. Refer to How To Power Off / On the Press and Control Center Using the Red Switch to Clear a Fault. If the problem persists, contact Support for additional assistance.

00: Black (K) Toner CRUM Not in Position.

Fault Code 093-926 occurs when an error is detected with the Black Toner cartridge, possibly due to the incorrect or incompatible toner cartridge installed.

The issue is due to a recently expired certificate included with the device firmware. The loss of this communication means that the meter reads, supplies replenishment information and maintenance information has stopped being transmitted and reported.

Most of the issues with non printing jobs and „Offline” messages are from driver settings. First check to see if there is no job in the print queue (delete any job if exist). Check the port to be on TCP/IP and not WSD. MS convert the port to WSD.

The issue is due to a recently expired certificate included with the device firmware. The loss of this communication means that the meter reads, supplies replenishment information and maintenance information has stopped being transmitted and reported.

Fault Code 059-324: Fuser Under Temperature.

Re: Phaser 6510 error code 124-315 After Power Cycling

Usually this problem only occurs if the NVRAM has been reset or the engine board has been replaced without backing up the NVRAM.