Pretty hard to replace. You can just reset the counter. The waste pad holds enough that you can reset it at least twice without worrying. Worst that can happen is ink leaks out the bottom of the printer. Read this thread for procedure. http://www.fixyourownprinter.com/forums/printer/40500
How to Identify and Fix Common printer Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
Look for a black rubber frame under the ink cartridge assembly. This contains the ink absorbing pads.
The error “Ink Absorber Full” means that the internal ink absorber or flushing box will need to be replaced. The need to replace these items and the time period before replacement is dependent on the number of purges and flushes required to clean the ink system.
Conclusion. If you want to re-use your waste ink, think about ways to use it for things like tie-dyeing, caligraphy or any manner of other craft activities (be aware that the inks are unlikely to be suitable for use by children!) but don`t use it in your printer.
When the message “Ink absorber full.” is displayed, the printer stops printing and needs ink absorber replacement. Push the power button to turn OFF the printer, and then contact the service center for replacement.
Soak for 15 minutes in mixture of 1 quart lukewarm water, one-half teaspoon liquid hand dishwashing detergent and one tablespoon ammonia. Rub gently from back to loosen stain. Soak another 15 minutes in above mixture. Rinse.
If your PC or the LCD screen on your printer is telling you that your ink cartridges are full but no ink is passing through to the paper, then it`s most likely that you are dealing with a clogged printhead. Blurry documents and images that appear faded are also signs that it`s time to remove the excess ink.
Background: The waste ink pad counter message is the result of the Epson F-mach printhead used in the AnaJet. Because the print head is used in several different types of printers, it tries to keep track of its usage.
A waste tank is whenever the printer does self-cleaning, it dunks some waste ink into a waste pad. Therefore if you do lots of cleaning, the waste tank will be full. You can look at the printer`s right back corner; there`s a screw secure the cover.
If your inkpad is used up you will get a faint impression but if it is just dried out this will reconstitute the ink. I alternate using Staz-On Reinker and Denatured alcohol because if you get too much reinker on the pad it feels sticky. *You can also use denatured alcohol to revive dried up alcohol pens.
A typical ink cartridge will yield 250 to 300 pages depending on the color density of the prints. The yield of a typical toner cartridge in a laser printer is between 2,500 and 3,000 pages. Some larger laser printers can even have toners that will yield up to 30,000 pages!
It is recommended that you clean any dirt from the inside of the printer while the print head is soaking or drying. In addition to cleaning agents containing alcohol, compressed air is ideal for removing dust from inkjet printers.
Alcohol that is 90% pure also works well. You can use 70% pure isopropyl alcohol, but if you do, you must wait much longer after cleaning to ensure that it is completely dry. For example, 99% isopropyl alcohol might dry in as quickly as one minute; 70% isopropyl alcohol can take as long as 15 minutes.
Only use alcohol-based pad cleaning fluid, the smallest amount required to do the job. Avoid strong solvents. Use them only for initial removal of silicone oil on the surface. After cleaning, apply rejuvenating oil to the surface before resting for at least 24 hours.