Unknown Printer

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Most of the issues with non printing jobs and „Offline” messages are from driver settings. First check to see if there is no job in the print queue (delete any job if exist). Check the port to be on TCP/IP and not WSD. MS convert the port to WSD.
When the printer`s front panel reads Waiting for manual feed. Insert one envelope , insert one envelope until it stops: Insert one envelope with the short end of the envelope entering the printer first, and with the flap side face-up and aligned with the left side of the manual feed slot.
Check to make sure the printer is turned on and connected to the same Wi-Fi network as your device. To find out if your printer is connected to Wi-Fi, see if your printer`s built-in menu has options for checking its Wi-Fi connection, or check the printer`s manual for instructions about how to add it to a Wi-Fi network.
This means that the printer is not properly connected to the network or computer. It may happen due to a faulty cable or a loose connection. Outdated Drivers: Another common reason for Xerox printers showing offline is outdated drivers.
My printer won`t print

Check there is paper in the tray (and it`s the right type of paper). Turn the printer off, wait 20 seconds and turn it back on again. Both USB and Wi-Fi connected printers require the correct and current printer driver is installed on the computer you`re printing from.

Using both hands, put one piece of paper in the manual feed slot until the front edge of the paper touches the paper feed roller. Once the machine has grasped the paper, let go. The side to be printed should be faced up. The machine will hold the paper in place until the print data is sent to the machine.
Connectivity Issues: One of the primary reasons why a Xerox printer may show “offline” is connectivity issues. This means that the printer is not properly connected to the network or computer. It may happen due to a faulty cable or a loose connection.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Xerox Phaser 7750 – FUSER delima
ANSWER : Thanks! On my printer, one of the magnets did dislodge and was stuck on the other side. I finally figured out what it was from your advice. The magnet was not broken and popped right back in to place. Keeping my fingers crossed that was the only issue.

Read Full Q/A … :
Unknown Printer

Phaser Jams every time code: 0,006.74
ANSWER : http://www.support.xerox.com/support/phaser-8560mfp/support/enus.html

Read Full Q/A … :
Unknown Printer

How to reset page counter on Xerox Phaser 3160N
ANSWER : http://apexmic.info/how-to-reset-chip-xerox-phaser-3160.html

Read Full Q/A … :
Unknown Printer

Xerox Phaser 3250 solid red light with no apparent reason
ANSWER : I found the problem to be a fuser. For $150 you can fix this issue. Cheaper to buy a new unit.

Read Full Q/A … :
Unknown Printer

xerox phaser 6100
ANSWER : This post is from nearly a decade ago, so don’t know if the thread is still active. I have this printer in my rural WV classroom and am searching for a fuser unit for the Phaser 6100. Anybody know where I can still purchase one ?

Read Full Q/A … :
Unknown Printer

Fault
ANSWER : That error indicates that the expected voltage from the power supply is not being drawn – if printer is plugged into surge protector it can get that error message as well. Printer should be plugged directly into an outlet.

Read Full Q/A … :
Unknown Printer

reset
ANSWER : Try in Tech Menu

Read Full Q/A … :
Unknown Printer

error code :91,720,00:60960
ANSWER : Xerox 8570 Error Code 91720

Read Full Q/A … :
Unknown Printer