reset colors for canon S400

With the printer powered on, select Setup . Select Device settings . Scroll to the bottom of the menu list and select Reset settings. In the Reset settings menu, select the desired area you want to set back to the factory defaults.

Open the Canon IJ Printer Assistant Tool. Make sure that the printer is on, and click Remaining Ink Notification Settings. Select the ink color and click Reset to reset the remaining ink level counter. When you reset the remaining ink level count, you must refill the ink tank to the upper limit line.

Disconnect the printer cable from the printer, turn the printer off, and then unplug the printer from the power supply. Plug the printer back in and turn the printer back on. If the problem is not resolved, contact your Canon service representative.

Open the printer`s web page and Sign in as Administrator. On the General tab select Reset Factory Settings in the menu.

Press the button on the chip-reset tool for several seconds until the LED light on the device goes off. Then, unlock the reset tool from the cartridge. Use the resetter with other cartridges and install them back into the corresponding slots in your printer. Voila!

First, check your printer settings on the file or picture your trying to print. If your page is setup to print in “grayscale” it will only print in black and white. Change the setting to “default” so it will print in color. If your settings look good from the start, the cartridge may just need to be primed.

Reset. Resetting the printer stops printing and clears the current print job received from the active interface. You may want to reset the printer when there is a problem with the print job itself and the printer cannot print successfully.

The reset key is a single use key and once used cannot be used again. All EPSON printers have inbuilt counters that count up the number of pages a printer produces, the number of head cleans executed and various other attributes. Once a critical level is reached the printer will enter its service mode.

According to Canon, Error 06 indicates a fault of the sensor cleaning module.

Solution. The ECM (Error Correction Mode) is a function for detecting and correcting errors during fax communication. Using the ECM function can diminish receive errors even over poor connections. The ECM function is available only when the settings for the sender`s and recipient`s machines are enabled.

Press (Settings/Registration). Press [Function Settings] → [Printer] → [Printer Settings].

The default user name for the administrator is “Administrator” and the default password is “7654321”. When you are going to operate the machine as “Administrator,” change the current password to improve the security.

The default user name for the administrator is “Administrator” and the default password is “7654321”. When you are going to operate the machine as “Administrator,” change the current password to improve the security.