Canon Pixma MG5350

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

If the paper feed rollers are dirty or have paper dust on them, the paper may not be fed properly. When this happens, you`ll need to clean the rollers twice: once with paper loaded, and once without.
The common reasons for this issue are various, for instance, the paper input tray is overloaded, dust or moisture can affect the paper feed or paper pick rollers, the printer driver is old, etc. Thus, the printer cannot detect the paper that has been inserted into the tray.
A paper feed issue can occur for several reasons, such as dusty or contaminated paper rollers, the condition of the paper in the tray, or even issues with the software.
If the paper feed rollers are dirty or paper powder is attached to it, paper may not be fed properly. In this case, clean the paper feed rollers. Cleaning will wear out the paper feed rollers, so perform this only when necessary. Make sure that the power is turned on and remove any paper from the rear tray.
The paper trays are empty or overloaded. The paper is curled. The print side, or shiny side, of the paper is not loaded in the tray face down. For photo paper, always load the rougher side of the paper facing up.
Select > Paper Setting > paper source > Print Adjustments > Paper Feed Adjust.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :

Canon Pixma MG5350

Canon Pixma Printer Paper Does Not Feed Properly/"No Paper" Error Occurs?
ANSWER : Pretty much useless advice. I also have serious doubts about someone who is obviously not fluent in the English language.

Read Full Q/A … :

Canon Pixma MG5350

Canon PIXMA MP190 – paper pulls to one side and ja
ANSWER : My Canon MP470 pulled paper to one side. Thanks for the simple solution. It worked and made doing my taxes a little less of a pain.

Read Full Q/A … :

Canon Pixma MG5350

Paper feed problem
ANSWER : Those printers are really hard t.o take apart. As you can see, there are very few screws holding it together. All the panels snap on and aren’t meant to come back off for repair. What I do is gently pry around the panel with a small flat blade screwdriver until it pops up. There aren’t any manuals, so that’s pretty much the only way to do it. I’m pretty good at putting parts like that back in without disassembly. I’ve innovated different repair methods where I do the equivalent of laproscopic surgery with minimum disassembly. Maybe use a needle nosed pliers and a small screwdriver to help guide it in? I don’t know exactly where it came out of or how much access room you have.

Read Full Q/A … :

Canon Pixma MG5350

Canon mx410 Paper jam message, but no paper jam?!
ANSWER : I have exactly the same problem, no answers 😳

Read Full Q/A … :

Canon Pixma MG5350

Full Ink Tank in Canon Pixma ip4000
ANSWER : It had been exactly the same subject, could not find an appropriate broker and process for earnings finally had to rummage through the Web, and there I came across this page http://optioninvest.org .Possibly you’ll find there is a therapy to your condition, thanks for the fascination!))

Read Full Q/A … :

Canon Pixma MG5350

canon mp780 paper jam
ANSWER : Hey thanks a lot for the marvelous blog post for Canon printer. To get resolutions for all your problems contact us at our toll free number Canon Printer Help Desk Number UK 0800-098-8356.

Read Full Q/A … :

Canon Pixma MG5350

Print problem with Canon MP620
ANSWER : Open the front of the printer.

Read Full Q/A … :

Canon Pixma MG5350