HP LaserJet 2
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
Perform a power reset.
- Press the On/Resume button ( ) to turn on the product.
- With the product turned on, disconnect the power cord from the rear of the product.
- Unplug the power cord from the wall outlet.
- Wait at least 15 seconds.
- Plug the power cord back into the wall outlet.
Step one: Reset the product
Unplug the power cord from the wall outlet. Wait 30 seconds. Plug the power cord back into the wall outlet. Reconnect the power cord to the rear of the product.
Step one: Reset the product
Unplug the power cord from the wall outlet. Wait 30 seconds. Plug the power cord back into the wall outlet. Reconnect the power cord to the rear of the product.
Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button. The Attention and Ready lights cycle while the product restores factory defaults.
Step one: Reset the product
Unplug the power cord from the wall outlet. Wait 30 seconds. Plug the power cord back into the wall outlet. Reconnect the power cord to the rear of the product.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
13.20 Paper Jam "Open input trays, then open and close top cover"
ANSWER : Usually, it’s a scrap of paper stuck where the paper comes up out of the tray and takes the bend up into the printer. With the trays out, tilt the printer backwards and look up into the slot. You can usually see the paper stuck in the slot. If not, then take the cartridge out and lift up the flap at the front and look down there.
"Printer's cover is open" Error
ANSWER : Maybe a different cover is open. Did you check the back cover.
My encolder has come off and i Cant get the screws to come out to open up
ANSWER : torx driver for an hp if thats what you have
Canon Pixma iP3000 "Open door" Error code.
ANSWER : Look for a protruding plastic on the top that goes into an indentation. Mine was in the front left side. Put a piece of cardboard into the indentation.and close the door. The top plastic piece is not pushing the door close sensor down and because its too short and the cardboard allows the sensor to be reached and pushed.
Cant open HP Director in my mac
ANSWER : Try reinstalling it first from the CD and if that fails again, try downloading the software package from the official HP site and attempting an install that way. Apple makes it a pain to uninstall programs but doing an install on top of the existing one without first uninstalling could repair the issue. If you must uninstall the software there are programs that help uninstall programs from Mac systems.
pls open cover message on printer display
ANSWER : Follow the steps I’ve listed below for the solution to your problem.
Brother MFC 7220 "back cover open" error
ANSWER : Just googled this problem and delved into the innards of the machine. Lo and behold, there was a piece of paper stuck there and I have removed it (with difficulty). So it wasn’t “back cover” at all (which I kept on banging shut of course!). Misleading!