HP PSC – Printer / Scanner / Copier 2210
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
If your printer won`t print, a print job has stopped unexpectedly, or you received a “carriage jam” error, your printer carriage is likely jammed. These jams occur when the carriage holding the ink cartridges stalls in the printer. Carriage jams sometimes occur after a paper jam.
Improper placement or installation of the print cartridges can cause a carriage stall error condition. Follow these instructions to remove the print cartridges. Make sure the printer is turned on. Open the print cartridge access door, and then wait until the print carriage is idle and silent.
Why the Printer Cartridge won`t Move. A paper jam is usually the reason why an HP printer cartridge gets stuck on the right side. Pushing the paper excessively into the printer, on the other hand, is the most common cause of a paper jam. You should only push the paper until the first resistance.
If your printer won`t print, a print job has stopped unexpectedly, or you received a “carriage jam” error, your printer carriage is likely jammed. These jams occur when the carriage holding the ink cartridges stalls in the printer. Carriage jams sometimes occur after a paper jam.
Paper Feed Gear Problem: The paper feed gear is responsible for feeding the paper into the printer. If there is a problem with this gear, it can cause the carriage to jam. Cartridge Carriage Stalled: If the cartridge carriage is stalled, it can cause the printer`s carriage to become stuck.
Sometimes a paper jam error persists even though there is no jammed paper (false paper jam). Reset the printer, which might clear a false paper jam error, and then try to print again. With the printer turned on, disconnect the power cord from the printer. Unplug the power cord from the power source.
Low-quality paper leaves an accumulation of tiny paper bits often referred to as “paper dust” inside the machine. This “dust” is one of the top causes of paper jams. More dust means more jams. Besides jams, the dust also contributes to poor-quality prints and causes machine parts to wear at a faster rate.
Make sure you don`t overload the tray. A good way to stop the printer becoming jammed, is to fan the paper before you put it in the tray as this will shake out any dust and reduce static, which are two major causes of paper jams. Another way to avoid a printer paper jam is to keep your machine clean.
If it`s a draw-fire vape and you can`t take a pull, the battery is either already dead or there`s a clog. Use a needle to check the mouthpiece for possible clogs. The more viscous the oil, the more likely this may be a problem. Store the device with the mouthpiece up.
Why does my HP printer keep saying cartridge problem? Please check and wipe the cartridge contacts. The common cause of the cartridge problem message is the gold contacts found on an electronic chip on the body of the HP cartridge being cloaked with dirt or ink or even because of physical damage.
What to Look For. Chances are you suspect a faulty ink cartridge due to your print quality declining. Streaks, smears and stripes on your printout are all signs of a bad cartridge, as is a lack of a particular color or a color appearing very faint. Sometimes the printer refuses to print if a cartridge is faulty.
HP has determined that 99% of all lines and streaks on copies made by feeding the original documents through the ADF are caused by debris on the ADF glass. Debris can include dust, paper or toner dust, residue from sticky note adhesive, correction fluid or tape, ink, fingerprints, and more.
Low-quality cartridges or improperly stored cartridges can cause paper jams. For example, too much toner or ink can be released onto the paper, or the toner or ink can clump together in the cartridge.
Clean the contacts
If the contacts between the cartridge and the printer are dirty or clogged, there is a high chance that this can be the main cause for the ink to leak on the paper. To properly clean the contacts, open the printing machine and remove the ink cartridges and place them on a clean piece of paper.
A printer printing lines on the page are normally caused by a blocked, dirty, or damaged print head. Blocked ink cartridge nozzles, or not removing protective seals correctly when you installed a new ink cartridge can also cause missing lines of print.
You will test at the pins on the rear of the cartridge. Set the ohmmeter so it can read up to 10,000 ohms. Connect the ohmmeter leads to the white pin (L) and the blue pin (LG). The meter should read above 100 ohms and below 10,000 ohms.
— How tight do I need to screw the cartridge to the headshell? — Hand tight is usually enough. The force you can apply while holding a small screwdriver with just two fingers is the maximum you should use.
“A simple way to fix this is by removing the cartridge from the vape pen, getting a needle, and simply gently poking the needle through the airflow holes until the oily residue is gone,” advised Peki.
Ink cartridges can dry out over time. If they are sitting in your machine for an extended period, they will eventually dry up and become unusable. The simplest way to combat this problem is by printing more frequently or running regular cleans and ink tests to ensure the nozzles remain clean.
Ink cartridges can usually last two or three years if properly packaged and stored. But in a standard case, they will eventually dry out and become useless after this period. However, many major ink cartridge makers don`t put expiration dates on their cartridges.
You can continue to print with one or more empty cartridges, but HP recommends replacing them as soon as possible to avoid printhead damage.
Most commonly “Cartridge Problem” means that your HP printer simply cannot recognise the colour or black ink cartridges. Thankfully however this error message can usually be cleared with some basic troubleshooting.
If you are experiencing black lines on your copies when using the automatic feeder on your copy machine chances are your machine has a dirty slit glass. The slit glass area on your copier can get dirty for multiple reasons.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
After thr carriage stop moving the ramp will not lower to load or unload the ink cartridge.
ANSWER : Could be ink buildup jamming it. Try squirting Window cleaner around the ramp. That will dissolve the ink.
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP PSC 1510 copying problems
ANSWER : my hp photocopy is not working
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP PSC 2410 Carriage Jam
ANSWER : Hi All,
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP PSC 1210 Service Manual?
ANSWER : Hi Abe,
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP psc 1210 Wont Feed Paper
ANSWER : This printer seems to have special problems with paper feed asy. When functioning works
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP psc 2110 all-in-one won't turn on after power o
ANSWER : left the printer on now i cant get the printer to go on
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
Paper Jam and carriage jam code when nothing is jammed
ANSWER : Did you try cleaning the encoder strip that runs through the cartridge assy.? Use Window Cleaner on a paper towel. Also, check inside on the right. I’ve seen a lot of times where there is a folded up scrap of paper that stops the carriage from going all the way to the right.
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210
HP PSC 1610 ALL-IN-ONE
ANSWER : hy,
Read Full Q/A … :
HP PSC – Printer / Scanner / Copier 2210