Canon Pixma MX330
How do I repair the sensor for paper output?

Experienced technical support provide their insights in answering this question :
Printer jams happen when the paper encouraging through the printer goes amiss. Infrequently the printer overlooks the issue, officers ahead, and expels a folded mess into the yield plate; on different events, the printer stops in mid job, and the folded mess- – or a portion of it- – stays caught some place inside the machine.

How to Identify and Fix Common printer Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

One of the most common causes of paper jams is that the paper has simply not been loaded correctly into the printer paper feed. With this in mind, remove any paper from the tray in order to check for any jams. If you do see some paper jammed, pull each sheet out of the printer slowly until the printer is clear again.
Sometimes a paper jam error persists even though there is no jammed paper (false paper jam). Reset the printer, which might clear a false paper jam error, and then try to print again. With the printer turned on, disconnect the power cord from the printer. Unplug the power cord from the power source.
A paper jam is when paper or other printed material gets stuck or lodged in a printer and cannot eject.
Step one: Perform a power reset

Unplug the power cord from the wall outlet. Wait at least 15 seconds. Plug the power cord back into the wall outlet. Reconnect the power cord to the rear of the product.

Low-quality paper leaves an accumulation of tiny paper bits often referred to as “paper dust” inside the machine. This “dust” is one of the top causes of paper jams. More dust means more jams. Besides jams, the dust also contributes to poor-quality prints and causes machine parts to wear at a faster rate.
Do a hard reset on your printer. To do this you just need to turn off your printer, unplug for a few minutes and then plug the printer again. If that still doesn`t work, try turning the printer and your computer off, and then start it back up again. Try uninstalling and then reinstalling your printer driver.
Paper may be jammed if the rear cover is not closed completely. Push the rear cover until it is closed completely. If you cannot remove the paper or the paper tears inside the printer, or if the paper jam error continues after removing the paper, contact the service center.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :

Canon Pixma MX330

Paper Jam error but no paper jam
ANSWER : Obviously you didn’t get all the paper cleared out. There is a small scrap in the paper path causing the jam when the paper hits it. You can try clearing it out by inserting something stiff like a piece of file folder from the back of the printer into the paper path and pushing the offending piece out that way.

Read Full Q/A … :

Canon Pixma MX330

Paper Output Jam error
ANSWER : Printer jams happen when the paper encouraging through the printer goes amiss. Infrequently the printer overlooks the issue, officers ahead, and expels a folded mess into the yield plate; on different events, the printer stops in mid job, and the folded mess- – or a portion of it- – stays caught some place inside the machine.

Read Full Q/A … :

Canon Pixma MX330

Canon mx410 Paper jam message, but no paper jam?!
ANSWER : I have exactly the same problem, no answers 😳

Read Full Q/A … :

Canon Pixma MX330

Paper Jam and carriage jam code when nothing is jammed
ANSWER : Did you try cleaning the encoder strip that runs through the cartridge assy.? Use Window Cleaner on a paper towel. Also, check inside on the right. I’ve seen a lot of times where there is a folded up scrap of paper that stops the carriage from going all the way to the right.

Read Full Q/A … :

Canon Pixma MX330

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :

Canon Pixma MX330

paper jam error
ANSWER : Update: The specific error is 13.06.00

Read Full Q/A … :

Canon Pixma MX330

Error Message "Paper out" when paper loaded
ANSWER : Check your paper tray settings as printer may be looking for paper from the manual feed tray on top of printer.

Read Full Q/A … :

Canon Pixma MX330