HP LaserJet IIIP+

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

An Er/03 error message indicates the printer failed to pick a sheet of paper to print. Remove the stack of paper from the tray and check the condition of the paper. Reload the paper, and then try to print, copy or scan.
Er/61 displays, the Wireless button is amber, and the Cancel button is blinking. An error occurred during Wi-Fi Protected Setup (WPS) and the printer was not able to connect to the network. to clear the error, and then try again. For more information and wireless troubleshooting steps, go to Wireless Printer Setup.
P2 error indicates — An ID Copy job has been started. Fix — Turn over the identification card and press the ID Copy button to continue. Perform a power reset , Reset the printer to recover from printer errors or failures.
An Er/04, Er/05, or Er/06 error message indicates a paper jam. Find and clear the printer of any jammed paper, or reset the printer if the printer has no jammed paper.
Error Code 3 is a Windows error code that appears when the computer cannot find the specified path.
(Code 3)” The device driver may be corrupted, or you are runningout of memory; the system is running low on system memory and may need to free up or add more memory. If the computer has insufficient memory to run the device, you can close some applications to make memory available.
When HP`s latest update occurs, the printer will not print and will display the error message, “Indicated cartridges blocked for containing a non-HP chip. Event Code: 10.00. 46.” The update will occur automatically and without warning, and once updated, the change to HP OEM cannot be reversed.
SOLUTION: 98.00.

Turn the printer off, and then on. Use the Format Disk item in the Preboot menu. WARNING: The Format Disk option performs a disk initialization on the entire disk. The operating system, firmware files, and third-party files (among other files) will be completely lost.

An E2 error occurs when the printer attempts to print a single-page or multi-page print job, and the paper length selected in the print settings does not match the length of the loaded paper.
Error E 2 – No Resume Light

The printer receives a single-page printing job, detects that the paper length for the printing job does not match the length of the loaded paper, and then prints out the page with errors.

Paper Jam in Input Tray.
`Error 7` displays

An E7 error occurs when the printer is unable to prime the system and has reached the maximum number of prime attempts. For help, contact HP Customer Support.

The E3 error code indicates the unit has detected there is no refrigerant. The unit will require a repair service for refrigerant to be added, please visit Request a Repair page for further assistance.
#1 21.5:3 Service Station rack cannot be disengaged. Web Wipe motor is damaged or blocked. Switch the power off at the rear of the printer, manually pull the Print head Maintenance Cartridge to the front position and switch the printer on again.
A system error code, also known as an error message or error code, is a numerical code that identifies the type of error that has occurred in a computer system. These error codes are generated by the operating system or an application when something goes wrong, such as a program crashing or a device malfunctioning.
That error code translates to a tray 2 feed where the paper was detected as too long or too short. As tray 1 prints fine, you can rule out any sensor in the path that the manual feed takes.
This error indicates a RAM failure. The specific memory is internal memory not one of the dimm slots. You can try removing any additional memory first to see if the device will boot but likely this is a failure of the formatter and you would need to replace the formatter.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

What repair needs to be done for a "50 needs repair" message on an HP Laserjet IIIP?
ANSWER : I don’t know what you mean by good toner cartridges. They haven’t been built in about 10 years, so if they are new OEMs in the box, they are guaranteed to fail. The 50 error on that printer is mostly a burned out fuser lamp. This site was sold, so as you can see, there are no more kits available.

Read Full Q/A … :

HP LaserJet IIIP+

evenly spaced horizontal lines on hp laserjet III printout
ANSWER : The lines would be a toner cartridge problem. Which paper tray? The MF tray or the optional paper cassette?

Read Full Q/A … :

HP LaserJet IIIP+

HP LaserJet 1160 pick-up problem
ANSWER : Take the black rubber roller out. Clean it and turn it 90-180 degrees so there is fresh rubber in the “corner”.

Read Full Q/A … :

HP LaserJet IIIP+

HP DeskJet 510 – problem
ANSWER : Recently started to look for a trusted and high-quality work with a broker for binary options, but the search was not a very successful, and my friend who is already a few years makes this kind of activity offered me options brokers review – site who himself uses optionsbrokersreview.com

Read Full Q/A … :

HP LaserJet IIIP+

HP laser jet 3015 "Upgrade Error Call HP Support"
ANSWER : rgtr

Read Full Q/A … :

HP LaserJet IIIP+

HP PSC 2410 clicking noise problem
ANSWER : I have the same issue… I’ve tried everything above… I don’t believe it’s dust as this happens on and off occasionally… I think I may need to make a youtube video of me “fixing” this printer! I’m really frustrated with this thing!! If it doesn’t work soon, I’m gonna by the solution in the form of a hammer!

Read Full Q/A … :

HP LaserJet IIIP+

Paper Feed Problem on HP R80
ANSWER : In the last examination it is our origination of death which chooses our responses to all the inquiries life puts to us. The most pleasant spot to be is in somebody’s idea; the most secure spot to be is in somebody’s petitions.

Read Full Q/A … :

HP LaserJet IIIP+

HP PSC 1610 – problem installing hardware
ANSWER : If you want to get proper detailed information about hp printer then you should call on 1-888-924-2961 toll free number. They provide you step by step methods of installation process and driver support services.

Read Full Q/A … :

HP LaserJet IIIP+