MP 460 and 490

ANSWER : I worked fixing printers for 5 years for Verizon and some of the older printers were notorious for the waste receptacle filling and overflowing with ink. My solution was good old warm water. Remove the waste container and scoop out as much as you can with a small screwdriver, wiping the discard on a paper towel, then just run warm water from the faucet into the container till all the residue is removed. This is just water soluble ink folks, if you want to test it, scoop out a glob and dissolve it in warm water, its easy as pie. I never once bought a new ink discard reservoir. I just cleaned out my mobile 460 printer reservoir by the same method. There are no electrical connections its just all plastic.

ANSWER : Hello Hamid:

ANSWER : Mine was grabbing the paper from the right side only (where the roller is), sucking the paper in partway and then going sideways and jamming. I cleaned off the roller to no avail. Then I picked the printer up and looked in the paper slot and found a small screwdriver lying sideways so deep you almost couldn’t see it. I got that out and now it works fine!

ANSWER : It means abnormal temperature in the print head. Only thing you can do other than replacing the print head is to try cleaning it. That’s done by removing all the ink tanks. On the right side of the cartridge assy., you’ll see a plastic lever. Lift that up to release the print head assy. It just lifts out from the back. Take it over to the sink and run hot tap water through the screens on top and then flip it over and run it over the heads on the bottom. Repeat a few times and then reinstall and try again.

ANSWER : It would be ideal if you take after the progressions beneath:

ANSWER : The problem is not much clear from your side. If your printer is not properly working and you tried to fix it out you couldn’t able to fix it. Nothing to worry about leave this problem to us. we are a company which deals in Canon Printer Tech Support Services. Call at Toll free Number 1-800-243-1403