Unknown Printer

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

The toner cartridge is not set correctly or not installed. Set the toner cartridge correctly. If the cartridge is installed, close the front cover and turn the power switch to off and to on. If the message appears again, contact your sales or service representative.
The No Toner message appears if the toner cartridge or the toner cartridge and drum unit assembly is not installed correctly. Remove the toner cartridge and drum unit assembly. Remove the toner cartridge from the drum unit, and reinstall the toner cartridge back in the drum unit.
Press the button on the chip-reset tool for several seconds until the LED light on the device goes off. Then, unlock the reset tool from the cartridge. Use the resetter with other cartridges and install them back into the corresponding slots in your printer. Voila!
Verify the ink cartridge(s) is inserted properly. Some cartridges snap in place, and if they are not inserted fully, the printer won`t print anything. If a lever is moved from its original position to allow for installation of ink cartridges, ensure it is returned to its original position.
Open the Canon IJ Printer Assistant Tool. Make sure that the printer is on, and click Remaining Ink Notification Settings. Select the ink color and click Reset to reset the remaining ink level counter. When you reset the remaining ink level count, you must refill the ink tank to the upper limit line.
This error occurs due to the chip on your cartridge still reporting a low or empty ink level from its previous use. The chip itself cannot be reset, so when the cartridge is refilled and then installed into a new machine it will still register as empty.
Locate the waste toner container sensor near the bottom of the Waste Toner Container. Clean the transparent plastic square. Clean the black sensors inside the printer, where the waste toner container sensor is located during normal operation. Power on the printer without the Waste Toner Container installed.
Turn off the printer and remove the toner cartridge. Look inside the printer in the area below where the cartridge goes. The toner sensor is on the right-hand side.
Locate the waste toner container sensor near the bottom of the Waste Toner Container. Clean the transparent plastic square. Clean the black sensors inside the printer, where the waste toner container sensor is located during normal operation. Power on the printer without the Waste Toner Container installed.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Expired Toner and Suggestions for Source of Toner
ANSWER : Hi Frank, I had a very similar question two weeks ago, but my “old beloved workhorse” is an HP Laserjet 4L. From the good old days! I too had made bad investments in “new but old truly HP” toner cartridges, hoping to coax more life from my printer. I ended up choosing to try a remanufactured cartridge from www.4inkjets.com. It was a gamble, but the website said they had a 100% satisfaction guarantee. And I can tell you they have lighting fast service. I’ve now printed 50 pages without a flaw. JOY! While the cartridges and technology are different, I suggest you try the same place. And good luck!

Read Full Q/A … :
Unknown Printer

Good toner cartridges still available for HP LJ 4V?
ANSWER : Try directpreciseimaging.Com in Calif. Don’t worry about resistance unless there is none.

Read Full Q/A … :
Unknown Printer

Brother toner cartridge low toner override
ANSWER : Thank you. You are a genius. Of course this is not a substitute for cartridge replacement but it is great for extending the life of the color cartridges and allowing you to continue to print until you can get new cartridges.

Read Full Q/A … :
Unknown Printer

Brother toner cartridge low toner override
ANSWER : follow these steps:

Read Full Q/A … :
Unknown Printer

HP CLJ 8550 does not recognize new Magenta toner
ANSWER : There’s a menu option to tell the printer it has a fresh toner cartridge.

Read Full Q/A … :
Unknown Printer

toner cartrigdes and drums
ANSWER : You can, but there are good knock-offs and bad ones. I’ve run into ones that come totally empty. Ones that don’t have the chips installed that identify themselves to the printer. Ones that have sat on a shelf for years and fail on installation. I could go on, but I’m sure you get the idea. I use http://directpreciseimaging.com/ Mostly because I set him up in business and he’s local to me. I have very few problems with his products.

Read Full Q/A … :
Unknown Printer

Toner cartridge full, printer displays: "empty needs replacing"
ANSWER : I once went to a customer who had a similar issue. They had installed new cartridges and judging from the box, they looked OEM. Strange thing was they felt empty when lifted and they were missing the chip on the outside that tells the printer it is installed and keeps track of how many copies were printed with that cartridge. The printer has no other way of knowing if the cartridge is full or empty.

Read Full Q/A … :
Unknown Printer

Waste Toner Cartridge is empty but printer is still telling me to replace it
ANSWER : All of the ones I’ve seen are optical. Light shines through a transparent section of the waste box onto a photocell. If toner builds up past that area, it gives a warning to replace it. Possibly toner dust has gotten on the photocell.

Read Full Q/A … :
Unknown Printer