Canon FC 1
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
When the message “Ink absorber full.” is displayed, the printer stops printing and needs ink absorber replacement. Push the power button to turn OFF the printer, and then contact the service center for replacement. Request either Canon or the dealer you purchased the machine for a repair service.
Press and hold the “Power” button and reconnect the power cord. When the printer comes on, release the button. Wait five seconds and push the “Power” button again. This resets the printer`s internal memory and overrides the “Ink Absorber Full” error code.
The purpose of the waste ink absorber is to safely collect any waste ink expelled during cleaning of the print head and borderless printing on photo printers. Over time this waste ink absorber can become full and will need to be replaced.
This error occurs due to the chip on your cartridge still reporting a low or empty ink level from its previous use. The chip itself cannot be reset, so when the cartridge is refilled and then installed into a new machine it will still register as empty.
Isopropyl alcohol isn`t strong enough to melt the sponge but is still strong enough to dissolve the ink inside the blocked printer head.
Rubbing alcohol will dilute and release the ink, as will hairspray in many cases. Damp two paper towels with your solution of choice and sandwich the stain between the two. Start blotting the stain from both sides to lift the ink.
The hard reset helps you restore your Canon printer back to its default factory configuration. Here`s how to perform a hard reset: Step 1: Press and hold the “Stop” button on your Canon printer until you hear the alarm ringing. Step 2: Release the “Start” button only after the alarm flashes or rings at least 19 times.
5B02 error – ink absorber full.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Canon pixma – ink absorber almost full
ANSWER : They are on the bottom of the printer. If you want to clean them, you can take them out and wash them in hot tap water. Wring them out like a sponge. You will need to reset the printer. http://jezpinions.blogspot.com/2012/03/canon-mg6150-ink-absorber-reset-error.html
Canon iP1700 ink absorber reset and remove/clean
ANSWER : The 6 step directions about tank full error worked perfectly for me to correct the problem
Reset ink absorber full
ANSWER : Free download of resetter here http://www.k58n.com/3ammresetter/canonresetter/410.html
replacing waste ink absorber on Canon Pixma ip6000
ANSWER : ditto, ditto & ditto
ip4200 INK TANK RESET and WASTE TANK RESET
ANSWER : Different cartridges, notwithstanding, don’t have a ‘fill gap’ so you’ll have to make one yourself. Our refill units for these sorts of cartridges accompany a smolder apparatus which is utilized to blaze (really dissolve) a fill opening in the cartridge . Our refill guidelines will demonstrate you precisely where to make the fill opening (you would prefer not to make it in the wrong spot). A blaze device come standard in all refill packs for cartridges without processing plant made fill openings. if you want to get proper detailed information then call us at 1-888-924-2961for more information regarding canon printer support.
Full Ink Tank in Canon Pixma ip4000
ANSWER : It had been exactly the same subject, could not find an appropriate broker and process for earnings finally had to rummage through the Web, and there I came across this page http://optioninvest.org .Possibly you’ll find there is a therapy to your condition, thanks for the fascination!))
Trying to reset Canon MP280's waste absorber
ANSWER : SSSSS
How to reset ink cartridge Canon Pixma MG6320
ANSWER : Your post is a bit confusing. You don’t reset the chip, you pull off the old one and replace it with the one they gave you.