How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
Insert the stack of paper into the product, and then gently push the paper guides snugly against the paper. Make sure that the paper is fully inserted into the product. Try printing again. If the issue is not resolved, try loading different brands of paper and different types of paper, one type at a time.
If roll paper does not feed, cut the end straight across and uncurl it by rolling it backward, if necessary. Then reload the paper. If thick media does not feed, make sure you are loading it straight into the product, not at an angle. If paper jams when you print on both sides of the paper, try loading fewer sheets.
Step one: Reset the product
Unplug the power cord from the wall outlet. Wait 30 seconds. Plug the power cord back into the wall outlet. Reconnect the power cord to the rear of the product.
Select Start , then select Settings > Devices > Printers & scanners . Scroll down to Related Settings and select Print server properties. Select the Drivers tab, and see if your printer is listed. If it is, you`re all set.
With dot matrix printers, paper is often feed through pins on a wheel that grab and slowly move paper through the printer. With inkjet and other page printers, paper is fed through the printer with rollers that grab and move the paper through the printer.
Rotating the roller by turning the deep side of the drive axis clockwise (1), wipe the roller in the direction of the arrow from the front to the back. Clean the roller until there is no visible dirt or dust on the entire circumference of the paper transfer roller. Visually check that there is no dirt or dust.
There are a few things that could be the cause of this problem, including: Empty ink or toner cartridges that need replacing. Ink or toner cartridges that have become dislodged from their proper place. The wrong paper size loaded in the input tray.
Reasons why your HP printer has ink but won`t print
This may seem obvious, but it sometimes happens: first make sure your paper tray has paper in it. Misalignment, clogged printheads, faulty data communication or insufficient ink levels can also be sources of the problem.
This is often caused by the fact the pick-up roller is worn out. The layer of rubber around this plastic part overtime gets too smooth, preventing paper from feeding properly into the printer. This fix is not really hard, will take no more than half an hour and costs around 10,- (Euro or Dollar).
HP Photosmart 8750 intermittent serv. stat. stuck
I had this error after the printer sat idle for many months. I thought it was the cartridge drive belt stretching, because it was extremely loose and wouldn’t move the carriage due to slippage. Then I noticed there was a gear belt tensioner to the right side that had some movement. Sure enough, when I shined a flashlight into the ink reservoir, there was a spring that had fallen down inside. Looking at the plastic belt tensioner, it looks as if the spring was held on by a plastic post that had broken off. This is most likely the cause of many of these errors, because the plastic break is very clean and not readily visible, (a design flaw in my opinion). Rather than trying to replace the part, I am going to try tapping a hole in the plastic and inserting a machine screw that can hold the tension spring in place. It also looks like the metal notch for the right hand loop of the spring, would not prevent the spring from slipping off at some point, so using a metal file to enlarge the notch may be necessary. If you’re lucky, your spring may have just popped off and is inside the ink reservoir. This may be one reason why the printer was discontinued so soon. One lousy five dollar part makes the whole printer worthless… I use this this printer primarily because it is easy to clean the heads by removing the carts, instead of having to disassemble the whole damn thing, as in ink tank designs. It makes beautiful 13×19 prints with better color accuracy than my Vivera 6 ink printer.