HP LJ 4350 – horizontal print lines and grinding

The streaks or lines might be caused due to low ink levels in one or both ink cartridges. Check the ink levels using the HP Toolbox to determine if the ink cartridges are low on ink and need to be replaced. note: Ink level warnings and indicators provide estimates for planning purposes only.

A printer printing lines on the page are normally caused by a blocked, dirty, or damaged print head. Blocked ink cartridge nozzles, or not removing protective seals correctly when you installed a new ink cartridge can also cause missing lines of print.

Conclusion. If your laser printer is causing horizontal black lines you either have a problem with the optics or the drum. Cleaning the optics and replacing the drum should fix the problem in most cases.

If you notice white or dark lines in your prints (also called banding), try these solutions before you reprint: Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. Make sure the paper type setting matches the type of paper you loaded.

When your printer leaves black lines, the lines indicate that there are excess toner powders on the rollers or transfer belt within the printer. As the paper is moved along by the rollers and transfer belt, any excess powder left on them can result in lines being left on the paper.

Program Settings

Although the printer might be correctly configured to print in Portrait mode, the program itself might be configured to print in Landscape mode. These settings are typically adjusted by locating a Page Setup or Page Layout menu and then looking for Orientation.

Streaks and unwanted lines could mean that the printer heads are out of alignment. There`s an alignment tool in the printer`s control panel. If that`s not the issue then the printer is dirty. Printer ink stripes may appear along the edges of the paper, which means there`s ink on the rollers and other parts.

A horizontal line is a straight line that goes from left to right or right to left. In coordinate geometry, a line is said to be horizontal if two points on the line have the same Y- coordinate points. It comes from the term “horizon”. It means that the horizontal lines are always parallel to the horizon or the x-axis.

Streaking is usually caused by a worn out drum unit or spent toner cartridge. Drum units are a consumable and only need to be replaced after the use of 3 or 4 toners. Not all printers use a separate toner and drum unit.

There are four primary causes for horizontal banding on prints from inkjet printers, (1) nozzle clogs, (2) mis-aligned print heads, (3) low quality print settings (4) incorrect paper thickness settings. Below we will describe each of these causes for horizontal banding as well as ways to try and fix them.

When your printer leaves black lines, the lines indicate that there are excess toner powders on the rollers or transfer belt within the printer. As the paper is moved along by the rollers and transfer belt, any excess powder left on them can result in lines being left on the paper.

White lines will typically start appearing on your print outs due to a clogged up printer head. Your first port of call when solving this problem is to run the cleaning program on your printer, which should be accessible through its settings menu.