HP LaserJet 1300
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
If the light keep blinking and it does not print, then either your toner is empty or there is a jam somewhere in the printer. Take the toner out and give it a good shake to redistribute the toner. load and unload the media and try again.
The printer is either low in toner, the density is set too low, or the Economode may be turned on. Remove the toner cartridge and shake it. This will redistribute the toner and often will temporarily solve the problem. However, this usually indicates it is time to install a new cartridge.
Check that the correct paper is properly loaded into the printer and is not jammed. Replacing damaged cables, plugging in loose or disconnected cables, and fixing paper jams as necessary may resolve the issue.
Ink may have run out (The lamp on the ink tank flashes). If printing is in progress, you are recommended to stop printing, replace the ink tank, and then print again.
Troubleshoot a blinking orange light on HP DeskJet.
It indicates firmware issues, paper jams, or improperly installed cartridges. Resolve it by performing a power reset of your printer. Take out the installed cartridges. Disconnect the device by removing the power cord from the outlet and the rear end.
Do a hard reset on your printer. To do this you just need to turn off your printer, unplug for a few minutes and then plug the printer again. If that still doesn`t work, try turning the printer and your computer off, and then start it back up again. Try uninstalling and then reinstalling your printer driver.
Hope you are well, usually that error message stands for paper jam inside the printer, please check the rear door, remove the tray 2 and check for paper stuck.
To be specific, you should make sure that your printer has sufficient paper, ink or toner and without paper jam. If the printer cartridge`s status is faulty, you should replace it with a new one. After carrying out these operations, check if the HP printer can print properly. If not, try other methods immediately.
If your PC or the LCD screen on your printer is telling you that your ink cartridges are full but no ink is passing through to the paper, then it`s most likely that you are dealing with a clogged printhead. Blurry documents and images that appear faded are also signs that it`s time to remove the excess ink.
To assist better –
With the printer turned on, disconnect the power cord from the rear of the printer. Unplug the power cord from the wall outlet. Wait at least 60 seconds. Plug the power cord back into the wall outlet.
Blinking amber: The battery has reached a low battery level. When the battery has reached a critical battery level,the battery light begins blinking rapidly. Off: The battery is not charging.
The Status light stays yellow and on steady (not flashing) normally to indicate that there is data remaining in the printer`s memory. Press the GO button once to print the remaining data in memory.
Blinking amber: The battery has reached a low battery level. When the battery has reached a critical battery level,the battery light begins blinking rapidly. Off: The battery is not charging.
The Status light stays yellow and on steady (not flashing) normally to indicate that there is data remaining in the printer`s memory. Press the GO button once to print the remaining data in memory.
The Wireless light blinks when the printer is attempting to connect to the wireless router or access point. Wait a few minutes, and then check the light again. If the Wireless light is on and steady, the printer is connected and you can stop troubleshooting.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
HP laser jet 3015 "Upgrade Error Call HP Support"
ANSWER : rgtr
Read Full Q/A … :
HP LaserJet 1300
HP PSC 1510 copying problems
ANSWER : my hp photocopy is not working
Read Full Q/A … :
HP LaserJet 1300
HP LaserJet 1160 pick-up problem
ANSWER : Take the black rubber roller out. Clean it and turn it 90-180 degrees so there is fresh rubber in the “corner”.
Read Full Q/A … :
HP LaserJet 1300
HP DeskJet 510 – problem
ANSWER : Recently started to look for a trusted and high-quality work with a broker for binary options, but the search was not a very successful, and my friend who is already a few years makes this kind of activity offered me options brokers review – site who himself uses optionsbrokersreview.com
Read Full Q/A … :
HP LaserJet 1300
HP PSC 1610 – problem installing hardware
ANSWER : If you want to get proper detailed information about hp printer then you should call on 1-888-924-2961 toll free number. They provide you step by step methods of installation process and driver support services.
Read Full Q/A … :
HP LaserJet 1300
HP PSC 2410 clicking noise problem
ANSWER : I have the same issue… I’ve tried everything above… I don’t believe it’s dust as this happens on and off occasionally… I think I may need to make a youtube video of me “fixing” this printer! I’m really frustrated with this thing!! If it doesn’t work soon, I’m gonna by the solution in the form of a hammer!
Read Full Q/A … :
HP LaserJet 1300
Paper Feed Problem on HP R80
ANSWER : In the last examination it is our origination of death which chooses our responses to all the inquiries life puts to us. The most pleasant spot to be is in somebody’s idea; the most secure spot to be is in somebody’s petitions.
Read Full Q/A … :
HP LaserJet 1300
HP Officejet 7310 problem
ANSWER : My HP Officejet7310xi All-in-One has an error message 0x886a789a on a blue screen, with Auto Answer, !, and Power (Print On) flashing. What does this indicate?
Read Full Q/A … :
HP LaserJet 1300