HP LaserJet 1300
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
The printer is either low in toner, the density is set too low, or the Economode may be turned on. Remove the toner cartridge and shake it. This will redistribute the toner and often will temporarily solve the problem. However, this usually indicates it is time to install a new cartridge.
There are a few things that could be the cause of this problem, including: Empty ink or toner cartridges that need replacing. Ink or toner cartridges that have become dislodged from their proper place. The wrong paper size loaded in the input tray.
The paper might not be engaged with the feed rollers. The paper-width guide is pressed against the paper stack too tightly. The paper tray is not completely inserted into the product. The paper settings in the print driver do not match the paper loaded in the paper tray.
If you`ve checked your ink cartridges and they still have enough ink to print, chances are that your printer might still randomly produce blanks. Some of the reasons why you still get blank printouts include: Congested nozzles. Improper cartridge installation.
Select Start , then select Settings > Devices > Printers & scanners . Scroll down to Related Settings and select Print server properties. Select the Drivers tab, and see if your printer is listed. If it is, you`re all set.
Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button. The Attention and Ready lights cycle while the product restores factory defaults.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
HP LaserJet 2200D won't print configuration page
ANSWER : Find someone with a HP LaserJet 4100 and you can configure the card to the IP you want:
Read Full Q/A … :
HP LaserJet 1300
HP Laserjet 1320tn printing grey instead of black
ANSWER : Try this test. Put a page into the manual feeder and do that same test. When the end of the page is just about to enter the printer, open the lid. Take out the toner cartridge and pull back the shutter. Look at the image and see if it is black. The explanation is that there is high voltage going to both the toner cartridge and the charge transfer roller below it. If the image on the drum is black, then the fault is at the transfer roller not getting enough high voltage. The transfer roller pulls the image off of the drum and down onto the paper. It would not be a laser scanner problem as any issue with it would not result in an overall gray image, but combination of gray and black. It will probably turn out to be a bad HV power supply, which will need replacement. I’ve never seen this particular problem on this model.
Read Full Q/A … :
HP LaserJet 1300
HP Color Laserjet 3800 problem when printing color
ANSWER : Do a cold reset
Read Full Q/A … :
HP LaserJet 1300
How to copy a card slot in HP laserjet 4250N
ANSWER : None that I know of, using a computer is likely your best option but I never attempted it.
Read Full Q/A … :
HP LaserJet 1300
HP Laserjet 4250 – RFU LOAD ERROR
ANSWER : Italiano:
Read Full Q/A … :
HP LaserJet 1300
evenly spaced horizontal lines on hp laserjet III printout
ANSWER : The lines would be a toner cartridge problem. Which paper tray? The MF tray or the optional paper cassette?
Read Full Q/A … :
HP LaserJet 1300
HP Laserjet 4200 50.2 Fuser error
ANSWER : if you are using a good fuser the next part to try would be low voltage power supply
Read Full Q/A … :
HP LaserJet 1300
HP laser jet 3015 "Upgrade Error Call HP Support"
ANSWER : rgtr
Read Full Q/A … :
HP LaserJet 1300