hp LaserJet 9050-must push go button to print

HP LaserJet 9050

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

M9050: Speed is 50 ppm A4 size and 50 ppm Letter-size.

The printer is either low in toner, the density is set too low, or the Economode may be turned on. Remove the toner cartridge and shake it. This will redistribute the toner and often will temporarily solve the problem. However, this usually indicates it is time to install a new cartridge.

Cold resetting a printer resets the printer to factory defaults. This is helpful in cases where you feel that some of the printer`s settings are incorrect, like paper size & type settings, advanced print quality settings, and even network and communications settings.

This printer has been discontinued.

Laser printers are faster than inkjet printers too. Print speeds are denoted in pages-per-minute (PPM). Laser printers have print speeds of 14 PPM and higher. The basic laser printer can print about 30 to 40 pages per minute, whereas high-end models churn out more.

In Windows, search for and open Add a printer or scanner . Click Add a printer or scanner, and then wait for Windows to locate available printers. If your printer is found, click it, and then click Add device to complete the driver installation.

Check That the Paper Tray Is Full (Not Jammed)

Try removing the paper tray, re-aligning the paper, and sliding it back in. In other instances, there may be some paper jammed in the mechanism. Usually your printer will tell you so, and you just need to open the access panel and pull the crumpled paper out.

You may see a “printer offline” error if your computer can`t communicate with your printer. This can be caused by loose cable connections or an outdated printer driver or operating system. The HP Smart app (below) can automatically diagnose and resolve printer offline issues in Windows operating systems.

Sometimes power cycling your printer can resolve the issue. Turn off your printer and unplug it, wait 30 seconds, plug your printer back in, and then turn the printer back on.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

HP LaserJet 2200D won't print configuration page

ANSWER : Find someone with a HP LaserJet 4100 and you can configure the card to the IP you want:

Read Full Q/A … :

HP LaserJet 9050

HP Laserjet 1320tn printing grey instead of black

ANSWER : Try this test. Put a page into the manual feeder and do that same test. When the end of the page is just about to enter the printer, open the lid. Take out the toner cartridge and pull back the shutter. Look at the image and see if it is black. The explanation is that there is high voltage going to both the toner cartridge and the charge transfer roller below it. If the image on the drum is black, then the fault is at the transfer roller not getting enough high voltage. The transfer roller pulls the image off of the drum and down onto the paper. It would not be a laser scanner problem as any issue with it would not result in an overall gray image, but combination of gray and black. It will probably turn out to be a bad HV power supply, which will need replacement. I’ve never seen this particular problem on this model.

Read Full Q/A … :

HP LaserJet 9050

HP Color Laserjet 3800 problem when printing color

ANSWER : Do a cold reset

Read Full Q/A … :

HP LaserJet 9050

How to copy a card slot in HP laserjet 4250N

ANSWER : None that I know of, using a computer is likely your best option but I never attempted it.

Read Full Q/A … :

HP LaserJet 9050

HP Laserjet 4250 – RFU LOAD ERROR

ANSWER : Italiano: