HP Color Copier 110

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

If you are seeing the 41.3 error on a LaserJet 4, 4Plus, or 5 series printer, and you find a blank sheet of paper in the path, your printer is probably having a failure with the solenoid on the paper feed assembly. This is becoming a common issue as these printers get older.
A piece of paper stuck in the paper tray or inside the printer can create a paper jam. Paper jams can occur for a variety of reasons, such as overloading the paper tray, loading different thicknesses of paper in the tray, or using paper that isn`t appropriate for your particular printer.
Loading paper that is stuck together, frayed, curled or bent can cause a jam. Overloading the paper tray, loading different thicknesses of paper in the tray or using paper that isn`t appropriate for your particular printer can all result in a jammed printer.
A piece of paper stuck in the paper tray or inside the printer can create a paper jam. Paper jams can occur for a variety of reasons, such as overloading the paper tray, loading different thicknesses of paper in the tray, or using paper that isn`t appropriate for your particular printer.
This means the baud rate is 9600 7 E for both the scanner and scale. If one tries to configure this Dual Cable device to a Single Cable device via bar codes it will beep once, reading the bar code, then emit a razz tone and throw an Error 13.
Hope you are well, usually that error message stands for paper jam inside the printer, please check the rear door, remove the tray 2 and check for paper stuck.
A paper jam is when paper or other printed material gets stuck or lodged in a printer and cannot eject.
Common causes of paper jams include: Damaged rollers. Inserting paper that is incompatible with the printer. Loading the paper incorrectly.
Pull out the sheets of paper that are jammed.

Gently hold on to the paper and pull it out of the laser printer. Try to pull the paper in the direction that it normally feeds. Pulling it backwards can damage the laser printer`s function. Remove all of the paper and scraps.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

HP Laserjet 6MP wont feed paper
ANSWER : I had a similar paper pickup problem on laserjet 6mp. The printer would go through start-up sequence fine but when it received a print job you could here the main gears/rollers turning but no clicking from paper pickup solenoid, then eventually error lights would come one . I incorrectly assumed it was an error with the paper pickup mechanism and wasted a whole day taking the printer apart and replacing the paper pick mechanism. Long story short, if I had bothered to figure out the secondary error light codes from the start, I would have realized it was just a bad fuser and would not have wasted so much time.

Read Full Q/A … :

HP Color Copier 110

HP Laserjet 4 Plus LED display dim
ANSWER : My HP Laserjet Plus’s LED display went blank around 6 weeks ago. It had been acting strangely for about a month, when ready, instead of the usual 00 READY it would display 000READY, which got my attention. Well, it suddenly went entirely AWOL. The service manual said to check:

Read Full Q/A … :

HP Color Copier 110

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :

HP Color Copier 110

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :

HP Color Copier 110

Paper Jam 13
ANSWER : Sticky paper pickup solenoid. Since MF tray doesn’t use it, it works fine. Solenoid is located on right side of printer at the end of the paper pickup roller shaft. You need to remove the solenoid, take the plate and spring off the top and then scrape off the gooey residue that’s causing it to stick. Then you get a thin piece of sticky backed felt and put it on top of the metal base. You can find some at the local hardware store, they’re used on the bottom of chair legs.

Read Full Q/A … :

HP Color Copier 110

HP LaserJet 1200 Early Feeding Causes Paper Jam
ANSWER : Seriously, dmzcompute, you are awesome! And this is just what the internet does so well: a specific fix for an esoteric problem, thus keeping a 15 year old machine alive another day. Thank you!

Read Full Q/A … :

HP Color Copier 110

LaserJet 4 won't Power Up
ANSWER : I haven’t seen that particular behavior on that model. It either works or it doesn’t. My first choice would be the power supply.

Read Full Q/A … :

HP Color Copier 110

Paper Mismatch Error on HP C6150, C6180 or C7280
ANSWER : Thanks a lot for your informational post. I had been working online and making money through paypal generator if you also want to know the secrets behind what you can do with this free paypal money adder visit the website and take away cash in your account.

Read Full Q/A … :

HP Color Copier 110