HP LaserJet 2200DT

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Make sure your devices are properly connected with each other, and the network or the cable you use to connect these devices is normal. You can also try restarting your HP printer. Turn it off completely and unplug the power cord, leave it for a couple of minutes, and then plug the cord back and power on the printer.
The printer is either low in toner, the density is set too low, or the Economode may be turned on. Remove the toner cartridge and shake it. This will redistribute the toner and often will temporarily solve the problem. However, this usually indicates it is time to install a new cartridge.
Turning the power ON/OFF while the print monitor screen is displayed may cause the printer driver to go off-line and make printing impossible. In this case, open the [Printers / Printers and Faxes / Devices and Printers] folder on the computer and check if your printer driver is shown as off-line.
Restart your computer, and then immediately press the F11 key repeatedly. Click Start . Press and hold the Shift key, click Power, and then select Restart while holding the Shift key. Continue holding the Shift key while the computer restarts.
Verify the ink cartridge(s) is inserted properly. Some cartridges snap in place, and if they are not inserted fully, the printer won`t print anything. If a lever is moved from its original position to allow for installation of ink cartridges, ensure it is returned to its original position.
Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button. The Attention and Ready lights cycle while the product restores factory defaults.
Verify the ink cartridge(s) is inserted properly. Some cartridges snap in place, and if they are not inserted fully, the printer won`t print anything. If a lever is moved from its original position to allow for installation of ink cartridges, ensure it is returned to its original position.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

HP Color Laserjet 3800 problem when printing color
ANSWER : Do a cold reset

Read Full Q/A … :

HP LaserJet 2200DT

HP LaserJet 2200D won't print configuration page
ANSWER : Find someone with a HP LaserJet 4100 and you can configure the card to the IP you want:

Read Full Q/A … :

HP LaserJet 2200DT

HP Laserjet 1320tn printing grey instead of black
ANSWER : Try this test. Put a page into the manual feeder and do that same test. When the end of the page is just about to enter the printer, open the lid. Take out the toner cartridge and pull back the shutter. Look at the image and see if it is black. The explanation is that there is high voltage going to both the toner cartridge and the charge transfer roller below it. If the image on the drum is black, then the fault is at the transfer roller not getting enough high voltage. The transfer roller pulls the image off of the drum and down onto the paper. It would not be a laser scanner problem as any issue with it would not result in an overall gray image, but combination of gray and black. It will probably turn out to be a bad HV power supply, which will need replacement. I’ve never seen this particular problem on this model.

Read Full Q/A … :

HP LaserJet 2200DT

HP Laserjet 2200, Tray 2 Pickup Problem, Gears Clicking
ANSWER : Definitely not a solenoid problem. I’ve worked on tens of thousands of printers and never replaced a single solenoid. You probably knocked something loose when you installed the pickup roller. Maybe something to do with the gear on the end of the pickup roller shaft. You’ll need to take the gear assembly off to be able to see it.

Read Full Q/A … :

HP LaserJet 2200DT

HP Laserjet M3035xs RFU Upgrade
ANSWER : There’s no way.

Read Full Q/A … :

HP LaserJet 2200DT

HP 4250 13.06.00 Fuser output paper stop !
ANSWER : pick up solenoid

Read Full Q/A … :

HP LaserJet 2200DT

How to copy a card slot in HP laserjet 4250N
ANSWER : None that I know of, using a computer is likely your best option but I never attempted it.

Read Full Q/A … :

HP LaserJet 2200DT

Print without stopping
ANSWER : I would think it was probably a sticking pickup roller solenoid. To prove that, you should try the same job from the manual tray. That uses a different solenoid.

Read Full Q/A … :

HP LaserJet 2200DT