How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
If roll paper does not feed, cut the end straight across and uncurl it by rolling it backward, if necessary. Then reload the paper. If thick media does not feed, make sure you are loading it straight into the product, not at an angle. If paper jams when you print on both sides of the paper, try loading fewer sheets.
You need to ensure your HP printer has enough paper, ink, or toner, and it is not stuck on paper jam. Also, check the status of your printer cartridge and try replacing it with a new one if it is not good enough. In some cases, your HP printer stops printing after you replace its parts.
There are different methods of paper feeding. With dot matrix printers, paper is often feed through pins on a wheel that grab and slowly move paper through the printer. With inkjet and other page printers, paper is fed through the printer with rollers that grab and move the paper through the printer.
If the paper feed rollers are dirty or paper powder is attached to it, paper may not be fed properly. In this case, clean the paper feed rollers. Cleaning will wear out the paper feed rollers, so perform this only when necessary. Make sure that the power is turned on and remove any paper from the rear tray.
Start by choosing “File” and then “Print,” and clicking the “Position and Size” settings. Usually, the default option is “Scale to Fit Media,” which prints to the page margins. Deselect it, then manually enter scale, height and width values that equal the full size of your paper. Click “Print” to print your image.
Running out of ink
If your printer runs out of ink, obviously the pages will come out blank when you attempt to print out what you need. Most of your HP printers will already have some kind of indicator to let you know that you are running slot. Solution: The solution is a no-brainer. Replace the ink cartridges.
Sheet feeder: Holds the blank paper and automatically feeds the paper during printing.
Continuous form feed and friction feed are the two types of paper feeder mechanisms. Dot matrix printers use continuous form feed, and laser printers use friction feed.
Printer rollers are the small circular rubber pieces that help feed printer paper through your printer. Over time, they can accumulate dust from the paper and ink residue from printing double-sided pages. To clean your printer rollers, you`ll need to first locate them in your printer.
“Manual Feed” is an indication that your machine`s Tray Setting or the paper source in the printer driver has been set to Manual Feed, but there`s no paper loaded in the manual feed slot.
When it isn`t working properly, the quality of your prints can suffer. Signs of a bad transfer roller include streaking, squealing, jamming and odors emanating from the printer. Troubleshoot your transfer rollers to restore your prints to their normal high quality.
The feed roller in combination with the feed plate pushes the sliver against the opening roller. The opening roller rotates much faster than the feed roller. This means the fibres in the sliver are hooked by the saw tooth or pins and separated under a high draft ratio into individual fibres by the opening roller.
Clean the print head, if necessary. Make sure the paper size, orientation, and layout settings in your printer software are correct. Make sure your document does not contain blank pages. If your printer software has a Preview option, you can check for blank pages before you print and remove them, if necessary.
This is often caused by the fact the pick-up roller is worn out. The layer of rubber around this plastic part overtime gets too smooth, preventing paper from feeding properly into the printer. This fix is not really hard, will take no more than half an hour and costs around 10,- (Euro or Dollar).