HP 950c stuck

ANSWER : Thanks for the “loose, white rectangular piece” comment in my 990cse. I found this same white piece of rubber today jamming up the cleaning station carriage assembly and was wondering where it came from!

ANSWER : Eu decidi fazer um binário opções, o primeiro passo neste trabalho yavlyaetsya formação inicial e os fundamentos .. Put Options and Call Options Trading É por isso que eu escolhi um par de artigos de alguns sites na Internet, se você pode se perguntar vospolzovatsya put-call-options.com/br/what-are-options/binary-options-and-strategies

ANSWER : rgtr

ANSWER : I had this error after the printer sat idle for many months. I thought it was the cartridge drive belt stretching, because it was extremely loose and wouldn’t move the carriage due to slippage. Then I noticed there was a gear belt tensioner to the right side that had some movement. Sure enough, when I shined a flashlight into the ink reservoir, there was a spring that had fallen down inside. Looking at the plastic belt tensioner, it looks as if the spring was held on by a plastic post that had broken off. This is most likely the cause of many of these errors, because the plastic break is very clean and not readily visible, (a design flaw in my opinion). Rather than trying to replace the part, I am going to try tapping a hole in the plastic and inserting a machine screw that can hold the tension spring in place. It also looks like the metal notch for the right hand loop of the spring, would not prevent the spring from slipping off at some point, so using a metal file to enlarge the notch may be necessary. If you’re lucky, your spring may have just popped off and is inside the ink reservoir. This may be one reason why the printer was discontinued so soon. One lousy five dollar part makes the whole printer worthless… I use this this printer primarily because it is easy to clean the heads by removing the carts, instead of having to disassemble the whole damn thing, as in ink tank designs. It makes beautiful 13×19 prints with better color accuracy than my Vivera 6 ink printer.

ANSWER : I have the same issue… I’ve tried everything above… I don’t believe it’s dust as this happens on and off occasionally… I think I may need to make a youtube video of me “fixing” this printer! I’m really frustrated with this thing!! If it doesn’t work soon, I’m gonna by the solution in the form of a hammer!

ANSWER : To initialize: turn off – Press start and hold down while turning on, release after all three light light, you should see initialize disk hit check, and allow to boot.

ANSWER : bonsoir

ANSWER : What is the fuser? And how can it be changed?