HP Photosmart 7660

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

This condition occurs when paper is jammed inside the printer. To resolve the error, find and clear the printer of any jammed paper, or reset the printer if the printer has no jammed paper.
Answer: Red light blinking in L220 printer means the printer may have roller jam problem OR sensor problem occurs. So, please check for roller jam and fix it. Second, check the sensor`s head and clean it too.
The blinking red lights indicate that the input cover is not seated properly–or that it has been removed–and that the computer is powered on. There is a small switch near the top rear center of the mainboard, and a foam pad on the input cover that touches it. That switch is the chassis intrusion switch.
From the User Manual for your laptop, the light on the power button has the following descriptions. On: The computer is on. Blinking: The computer is in the Sleep state. Off: The computer is off.
Print blemishes after inserting a new cartridge. Slow print times. Abnormal noises. Paper jams and ripped paper.
A red and solid LED indicates that the battery of your Motion is low. The remaining battery is under 10%. A red and blinking LED indicates that the sensor is recording, but the battery is low.
Hi: The 5 beeps means there is a memory error of some kind. Might be a bad memory module, or you just may have to remove and reseat the memory modules. The first thing I would do is to remove and reseat the memory modules to see if that resolves the problem.
The Power button is blinking. This condition might be caused by an open ink cartridge access door, an empty input tray, a paper jam, or a carriage jam. An error message might display on your computer. If a `paper jam` error message displays on your computer, try the steps to clear the paper jam.
A blinking Power light might indicate a `Fatal Error,” that requires a printer reset. Follow these steps to reset the printer. Without turning off the printer, disconnect the power cord from the rear of the printer. Wait 30 seconds, and then reconnect the power cord to the rear of the printer.
The Diagnostic LED blinks red 6 times and the system beeps 6 times (once per second), then a 2-second pause follows: This indicates a pre-video graphic card error. To resolve the issue, complete the following steps: 1) Reseat the graphics card.
In your model the 4 beep, red flashing light code means that there is a power supply overload of some kind.
Troubleshoot a blinking orange light on HP DeskJet.

It indicates firmware issues, paper jams, or improperly installed cartridges. Resolve it by performing a power reset of your printer. Take out the installed cartridges. Disconnect the device by removing the power cord from the outlet and the rear end.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

HP 2200 – blinking attention light and tray 2
ANSWER : Nice day. (QUALITY IS OUR CULTURE)

Read Full Q/A … :

HP Photosmart 7660

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :

HP Photosmart 7660

Epson Stylus C90 (Red Light Continuously Blinks)
ANSWER : It looks like General Error occurs. Check for foreign objects inside the printer which may block the movement of printhead carriage, paper feed, etc.

Read Full Q/A … :

HP Photosmart 7660

HP psc 2110 all-in-one won't turn on after power o
ANSWER : left the printer on now i cant get the printer to go on

Read Full Q/A … :

HP Photosmart 7660

All panel lights blinking, printer doesnt respond
ANSWER : This is very easy process, you must change a new one

Read Full Q/A … :

HP Photosmart 7660

HP Officejet 5610 power error
ANSWER : Please help me to fix my hp 5610 all in one the problem error 0xd0620230 reset power

Read Full Q/A … :

HP Photosmart 7660

HP laser jet 3015 "Upgrade Error Call HP Support"
ANSWER : rgtr

Read Full Q/A … :

HP Photosmart 7660

HP 2200DN stopped with all 3 lights on
ANSWER : You need to press both buttons when you get the lights on. This will give you a secondary light code that tells you what is causing the failure.

Read Full Q/A … :

HP Photosmart 7660