HP Color LaserJet 2550LN
How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
When a 50.4F. 00 error is displayed on the control panel, it indicates that there is an issue with the fuser or the power outlet where the printer is connected. Turn the printer off, and then back on to clear the error. Ensure that the power outlet, to which the printer is connected, is in good working condition.
If you see the error message “50.2 Fuser Error” on your HP Color LaserJet CP2025 series printer, you probably need to replace the fuser. Fusers are a consumable part and it is expected over the life of the printer you will replace the fuser several times.
50.2 error indicates that the printer is not heating up fast enough. This can be caused by a bad heating element in the fuser but can also be caused when the printer does not have adequate power due to overloaded circuits or being plugged into a power strip or surge bar that limits current flow.
If you have NOT recently replaced the fuser or heavily jostled the printer around, then the 50.7 Fuser error indicates you have an actual fuser failure (the gearing pressure is not releasing) and the fuser needs replacing.
1. Paper Jams. Paper jams are a common problem for printers, resulting in time-consuming and frustrating delays. It can occur when loose sheets of paper get stuck in the rollers or feeding mechanism of the printer.
You may see a “printer offline” error if your computer can`t communicate with your printer. This can be caused by loose cable connections or an outdated printer driver or operating system.
To be specific, you should make sure that your printer has sufficient paper, ink or toner and without paper jam. If the printer cartridge`s status is faulty, you should replace it with a new one. After carrying out these operations, check if the HP printer can print properly. If not, try other methods immediately.
Check for obstructions in the carriage path Open the cartridge access door to get to the carriage inside the printer. Make sure the carriage is not obstructed by gently sliding the carriage side to side. Look for and remove any obstructions in the carriage path, such as crumpled paper or dislodged labels.
Check for obstructions in the carriage path Open the cartridge access door to get to the carriage inside the printer. Make sure the carriage is not obstructed by gently sliding the carriage side to side. Look for and remove any obstructions in the carriage path, such as crumpled paper or dislodged labels.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
HP laser jet 3015 "Upgrade Error Call HP Support"
HP Color Laserjet 500 series M551n Error 98.00.0C
ANSWER : I just ran into one of these on a 4 year old m551. Failed to complete startup at the end of disk check. Followed the above link for troubleshooting.
HP 4050 Error 13.1 & 13.20
ANSWER : I tried the fix you recommended but it still would not fix.
Error Code 51.1 says Printer Error No Kidding.lol
ANSWER : Sometimes turning off and on will allow you to print a few pages. The error is a beam detect error. The only real fix is to replace the laser scanner unit. Could be a loose connector on the scanner or DC controller from the scanner. That’s unlikely. You could try the only other free fix which is to open the scanner assy. and clean all the mirrors inside. The dust could obstruct the laser beam enough to cause the detect error.
HP Laserjet 4250 – RFU LOAD ERROR
HP Laserjet 4200 50.2 Fuser error
ANSWER : if you are using a good fuser the next part to try would be low voltage power supply
HP P1007 Printer Engine Scanner Error
ANSWER : My hp laserjet p1007 printer shows a massage that engine communication error