Unknown Printer

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Right-click the printer icon on your taskbar (in the lower right corner of your screen0 and select Head Cleaning. Follow the on-screen instructions. The processing light will flash while the printer performs the cleaning cycle.
Otherwise use a printer head cleaning solution recipe of 50% water and 50% rubbing alcohol. We also like a homemade printhead cleaning solution that is 8-parts Windex to 2-parts rubbing alcohol. This printer head cleaning fluid works like a charm and it`s cheap to make!
If the hot water soak did not unclog the print head, place the cartridge printer head in isopropyl alcohol and allow it to soak overnight. Use a damp paper towel to wipe off the print head area and dry carefully.
The sponge end of a blocked printer head can be cleaned with only one liquid other than water. This liquid is isopropyl alcohol. Isopropyl alcohol isn`t strong enough to melt the sponge but is still strong enough to dissolve the ink inside the blocked printer head.
Soak the Printhead

Fill a bowl with warm water (or a mixture of water and vinegar to clean the printhead) and place the printhead directly in it. Let it sit for five minutes or so. Pull the printhead out of the water and use a lint-free cloth or paper towel to remove the dried ink.

Gocolor Head Cleaning Solution Liquid 200 ml for Epson Printer White Ink Cartridge – Gocolor : Flipkart.com.
The Power Cleaning utility allows you to replace all of the ink inside the ink tubes. In the following situations, you may need to use this feature to improve the print quality. You printed or performed head cleaning when the ink levels were too low to be seen in the ink tank windows.
Clean the printhead nozzles.

Dampen a microfiber cloth with distilled water. Be sure to use distilled water to prevent any residue from being left behind. Avoid using a paper towel that could leave lint on your printhead. Carefully clean your printhead with the wet cloth to remove dried ink.

Printheads can be thoroughly cleaned by soaking them in a solution of water and ammonia for several hours and then washing them under warm running water. This method has worked for others, and it`s also cheaper than replacing the printheads.
A common method for cleaning the nozzle is to use a solvent like acetone.
A printer printing lines on the page are normally caused by a blocked, dirty, or damaged print head. Blocked ink cartridge nozzles, or not removing protective seals correctly when you installed a new ink cartridge can also cause missing lines of print.
If your printer is still skipping lines when printing, go to your print quality settings and set it to high quality. If this still doesn`t fix it, try getting new cartridges and using those to see if it makes a difference.
If the nozzle check page does not print satisfactorily (for example, if any segment of the printed lines is missing), there is a problem with the printer. This could be a clogged ink nozzle or a misaligned print head. See Cleaning the Print Head for details on cleaning the print head.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Epson printer can't recognize Epson ink cartridge
ANSWER : Hi, my name is Jim.

Read Full Q/A … :
Unknown Printer

Epson 7880 ink pump sucking ink
ANSWER : Not ink pump, but air pump, to put the ink feed under pressure.

Read Full Q/A … :
Unknown Printer

What fluid to clean epson head?
ANSWER : There’s only 1 left, so better hurry. http://www.rjettek.com/jiecr-ocp-rinse-epson-blue/

Read Full Q/A … :
Unknown Printer

Epson Artisan 835 print head cleaning question
ANSWER : I had the same problem. After reading the comments, I tried Liquid Wrench spray. 1st try got about sixty percent improvement. Tried again this time I let it set for about 10 min then did a head cleaning. Completely solved the problem. I am a little concerned about its use on plastic. So far so good.

Read Full Q/A … :
Unknown Printer

how to clean ink pad
ANSWER : It’s kind of hard to disassemble to get the pad out. Since the pad holds way more ink than when it gives the warning, it is easier to just reset the warning. Do a search on waste ink reset for that model.

Read Full Q/A … :
Unknown Printer

How To Buy Your Head Cleaning Solution
ANSWER : The new site owner doesn’t sell kits anymore. Try doing a search for Epson head cleaning kit on eBay.

Read Full Q/A … :
Unknown Printer

Need help for Epson Stylus color 3000 print head?
ANSWER : I need help changing the print head in my Epson 3000 – I have 2 printers – one will not stay in alignment and the other black ink is plugged and I have soaked it and cannot get it to budge.

Read Full Q/A … :
Unknown Printer

Epson Artisan 700 Ink Reset — Any Other Way
ANSWER : I really need the utility but How do I send you a message? I dont see your address

Read Full Q/A … :
Unknown Printer