HP LaserJet 1320
The printer does not have a paper jam

Experienced technical support provide their insights in answering this question :
Assuming it is the triangle shaped error light, it can mean the tray is empty, a door is open or there is a paper jam. Did you check thoroughly for a jam? I’ve opened them up and there was a paper stuck below the cartridge in plain sight. Happened more than a few times. That’s why I ask. Also remove the tray and look up into where the slot for the paper to feed into the printer is. Often, there is a paper stuck in there. Lastly, open the back and look carefully for any scraps of paper. People often neglect to mention there was a paper jam and they ripped it out and it didn’t come out in one piece. I guess that’s not important enough to convey to someone trying to fix it.

How to Identify and Fix Common printer Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

A `Low On Supplies` message and light blinks

The Status Indicator light blinks red and a Low On Supplies message displays in the HP sprocket app. The cartridge is almost empty, and the paper is running low. Both need to be replaced soon.

This issue might occur if the device settings are corrupted, incompatible drivers or due to hardware problems.
located on the back of the printer. While holding down the Reset button, turn on the printer, and continue to hold the Reset button until the printer is in the Ready state.
Answer: Red light blinking in L220 printer means the printer may have roller jam problem OR sensor problem occurs. So, please check for roller jam and fix it. Second, check the sensor`s head and clean it too.
A blue or green light indicates the printer is operating correctly, while a red light indicates an error has occurred.
Troubleshoot a blinking orange light on HP DeskJet.

It indicates firmware issues, paper jams, or improperly installed cartridges. Resolve it by performing a power reset of your printer. Take out the installed cartridges. Disconnect the device by removing the power cord from the outlet and the rear end.

The orange exclamation point usually indicates one of the following issues has occurred, Insufficient power, There is a paper jam in the printer. The top cover is open. No paper was loaded in the tray or the tray was not loaded properly. The printer goes into sleep mode or standby mode.
Turn the printer off. Disconnect the power cable from the printer for 30 seconds and then reconnect. Turn the printer on while you press and hold the Resume button for 10-20 seconds.
Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button. The Attention and Ready lights cycle while the product restores factory defaults.
If there is a line, the print cartridge is most likely your culprit. Replace the defective print cartridge with a new one. Place the print cartridge back in the machine. Print a test document to see if issue is resolved.
Here are the most common causes of a printer printing faded text or images: Low ink or toner levels. Toner sticking to the fuser roller or problems with the transfer roller. Low ink or toner density settings.
The streaks or lines might be caused due to low ink levels in one or both ink cartridges. Check the ink levels using the HP Toolbox to determine if the ink cartridges are low on ink and need to be replaced.
If your router is blinking orange, it is likely getting an upgrade and you should give it time before doing anything. However, if your internet is unavailable or slow, it can get stuck and the blinking will not stop. Resetting the router and the modem normally resolves the problem and restores the connection.
Troubleshoot a blinking orange light on HP DeskJet.

It indicates firmware issues, paper jams, or improperly installed cartridges. Resolve it by performing a power reset of your printer.

Troubleshoot a blinking orange light on HP DeskJet.

It indicates firmware issues, paper jams, or improperly installed cartridges. Resolve it by performing a power reset of your printer.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Error light is on
ANSWER : Assuming it is the triangle shaped error light, it can mean the tray is empty, a door is open or there is a paper jam. Did you check thoroughly for a jam? I’ve opened them up and there was a paper stuck below the cartridge in plain sight. Happened more than a few times. That’s why I ask. Also remove the tray and look up into where the slot for the paper to feed into the printer is. Often, there is a paper stuck in there. Lastly, open the back and look carefully for any scraps of paper. People often neglect to mention there was a paper jam and they ripped it out and it didn’t come out in one piece. I guess that’s not important enough to convey to someone trying to fix it.

Read Full Q/A … :

HP LaserJet 1320

Error Code 51.1 says Printer Error No Kidding.lol
ANSWER : Sometimes turning off and on will allow you to print a few pages. The error is a beam detect error. The only real fix is to replace the laser scanner unit. Could be a loose connector on the scanner or DC controller from the scanner. That’s unlikely. You could try the only other free fix which is to open the scanner assy. and clean all the mirrors inside. The dust could obstruct the laser beam enough to cause the detect error.

Read Full Q/A … :

HP LaserJet 1320

Samsung ML 2165 Error lights
ANSWER : Hi there, I am having the same problem. Stupidly I bought a second replacement (genuine Samsung) cartridge thinking it may have been a faulty cartridge as sometimes it deemed to work after a bit of messing around. SO NOW I HAVE ONE NEARLY NEW AND ONE COMPLETELY NEW ; ABSOLUTELY NO USE TO ME – unless I can get the printer to accept them.

Read Full Q/A … :

HP LaserJet 1320

Printer will not pick-up paper from either tray. All error lights are on.
ANSWER : That is a hard fault. You need to access the secondary fault codes to diagnose what is causing it. Follow the instructions at this link http://www.printcopy.info/?l=en&mod=free&chap=erc&brand=HP&model=LaserJet%205P&page=4

Read Full Q/A … :

HP LaserJet 1320

Error Message 4F on MFC 210C
ANSWER : Basically this kind of error caused by loss of voltage on print head. If this is the case then I suggest to buy a new printer rather than replace print head. Print head might be too costly.

Read Full Q/A … :

HP LaserJet 1320

All panel lights blinking, printer doesnt respond
ANSWER : This is very easy process, you must change a new one

Read Full Q/A … :

HP LaserJet 1320

Error Code 52.1M
ANSWER : Magenta laser error. The spinning motor bearings cause the squeal and that slows it down causing the error. You could try opening it and lubricating the motor shift with a drop of synthetic lubricant. Do not use more than a drop.

Read Full Q/A … :

HP LaserJet 1320

HP CLJ CP 5225 ERROR 55.0601
ANSWER : my printer cp5225 is giving me error code 55.0601 message which i can’t fix please help

Read Full Q/A … :

HP LaserJet 1320