HP Photosmart 3200
ink system has failed error code ocd 18a0201
How to Identify and Fix Common printer Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
Recommended action. Turn the printer off, wait 15 seconds and turn the printer back on (using the power switch located on the back of the printer). The error code should not appear again.
This error code can appear for a few reason such as cable issues, firmware errors or hardware faults. You can try the reset processes as stated at the top of the page, then if the error code still displays update the firmware, also try using different printer cables.
The 0XC18A0001 Error code happens if the software drivers between the print head and cartridges are destroyed. Go to your HP printer after visiting the Device Manager on your computer. The drivers connected to your HP Printer will now be listed. A cautionary sign will be placed in front of the damaged drivers.
The 24 character error code is a failure of the short Disk Self Test ( DST ) and would indicate that the Hard Drive is failing and needs to be replaced. Hi, It means the hard drive has failed the quick test and needs to be replaced.
Cause. The error may be caused if the wrong printer is set as the default printer, the printer driver is missing, or if there are conflicts in the device manager.
An E1 or E2 error indicates that the paper size setting does not match the paper size that is loaded.
1. Paper Jams. Paper jams are a common problem for printers, resulting in time-consuming and frustrating delays. It can occur when loose sheets of paper get stuck in the rollers or feeding mechanism of the printer.
a misprint or misspelling in a text.
Something usually causes the error to occur and this is usually a failed microchip, out of date chip or interruption when installing a new cartridge and this will have to be rectified before continuing. Most problems are usually from the last cartridge inserted, so start by replacing that cartridge.
Remove any jammed paper that is accessible from the input tray area. Press the Cancel button to try and automatically clear the paper jam. If the paper jam error persists, continue these steps to manually clear the jam. Gently remove any jammed paper and bits of torn paper from the input tray.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
Error Code 51.1 says Printer Error No Kidding.lol
Sometimes turning off and on will allow you to print a few pages. The error is a beam detect error. The only real fix is to replace the laser scanner unit. Could be a loose connector on the scanner or DC controller from the scanner. That’s unlikely. You could try the only other free fix which is to open the scanner assy. and clean all the mirrors inside. The dust could obstruct the laser beam enough to cause the detect error.
Error Code 52.1M
Magenta laser error. The spinning motor bearings cause the squeal and that slows it down causing the error. You could try opening it and lubricating the motor shift with a drop of synthetic lubricant. Do not use more than a drop.
Canon Pixma iP3000 "Open door" Error code.
Look for a protruding plastic on the top that goes into an indentation. Mine was in the front left side. Put a piece of cardboard into the indentation.and close the door. The top plastic piece is not pushing the door close sensor down and because its too short and the cardboard allows the sensor to be reached and pushed.
Error code sc27-04
Sorry the code is sc27-04
Dreaded 6000 Error Code
Did you read this forum thread? http://www.fixyourownprinter.com/posts/71048
Canon Pixma MP150 Error Code 5100
Make sure you check that a copy of Gustave Holst’s journey to the stars cassette isn’t stuck in there! haha. That’s what my error 5100 was all about, I was getting ready to dismantle the thing after threatening it with a water boarding.
printer error code unable to print 4f
Follow these instructions: