How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
This error refers to the Laser unit, which is responsible for all printing procedures. It does not have to do with the scanner or ADF. So, yes, you will have to replace the Laser unit to fix it. If you found this post helpful, you can let others know by clicking the “Accept as Solution” button.
A 52 error code is related to a failure of the laser scanner, the device writes the image to the drum unit in the printer before the toner is transferred to the drum. If powering off and leaving off for a few minutes does not clear the error then most likely the scanner is dead.
Solution 1: Install the correct driver for your device
The Code 52 error is mainly caused by the incorrectly signed driver file installed on your computer. You can replace it with the correct driver to fix the error. Your device manufacturer keeps updating drivers.
The 52 Scanner error indicates that the printer has experienced an internal hardware error. Turn the product power off, wait at least 30 seconds, and then turn the product power on and wait for it to initialize. If you are using a surge protector, remove it. Plug the product directly into the wall socket.
Err 50, Err 52 –
Inverter overload, Inverter peak current If the over current trip level is continuously exceeded, the inverter will shut down: wait 30 seconds and then restart. The Inverter can supply more power than the nominal power level for a short time. If the time is exceed the inverter stops.
Error 52 in this case directly maps to AIX/Linux errno 52 STALE FILESYSTEM. This condition can result when a SAN or iSCSI attached block device that serves as the backend storage for the failing directory/filesystem disconnects from the host briefly.
Check the cabling carefully, you may have damaged the Flat flexible cable that plugs into the scanner or pinched the wires that run across the front of the scanner. Also the codes are usually 52.
Error message “0x0000052e” indicates the following error: “Logon failure: unknown user name or bad password.”
Error 52 indicates the media roll has been depleted. Brady provides 10% extra media on each roll, so the media may read empty with a smalls amount of material remaining.
The “Scanner error 5” usually triggers when the scanner`s drive motor fails. Fortunately, replacing the scanner assembly (which includes the motor) is not considered difficult. Our installation instructions are available below. Click here to purchase a replacement scanner assembly.
The error displays for scanner hardware or power issues, such as a scanner bar jam or calibration issue, low scanner bulb temperature, or an internal or external electrical problem.
52.00 ERROR
Verify that the scanner motor connector and the ribbon cable from the ECU are firmly seated on the laser/scanner assembly. 2. Verify that the scanner motor connector is firmly seated in connector J402 on the ECU. You might have to remove the main cooling fan to see this connection.
52.00 ERROR
Verify that the scanner motor connector and the ribbon cable from the ECU are firmly seated on the laser/scanner assembly. 2. Verify that the scanner motor connector is firmly seated in connector J402 on the ECU. You might have to remove the main cooling fan to see this connection.
Recommended action. Turn the printer off, wait 15 seconds and turn the printer back on (using the power switch located on the back of the printer). The error code should not appear again.
The HP Color Laserjet CP2025 10.100 Supply Memory Error is normally the result of a chip error on one of the cartridges. First you should check that each cartridge has a chip, it could have just fallen out.