Canon Color Bubblejet (BJC) 5100

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Check the following: Make sure print head (cartridge) holder motion is not impeded by stabilizer, jammed paper, etc. Remove any impediment. Make sure the print heads (cartridges) are properly installed.
Make sure the ink cartridges are properly installed. Push up the ink cartridge lock lever until it clicks. Make sure that the ink cartridge holder motion is not impeded by stabilizer, jammed paper, etc. Remove any impediment.
Error 5100 is a general error from the Microsoft . NET installer that can have a number of meanings: . NET has already been installed and target computer needs to be rebooted.
Check the following: Make sure print head (cartridge) holder motion is not impeded by stabilizer, jammed paper, etc. Remove any impediment. Make sure the print heads (cartridges) are properly installed.
The Canon Printer error code 5011 is a common error and you can clear this error message within a few minutes. This error code appears when the ink cartridge holder is stuck, or a piece of paper is stuck on the cartridge holder. It may also happen due to a misplaced cartridge.
An ink tank(s) is not seated properly.
An ink tank(s) is not seated properly.
When the message “5100 / 5110 Printer error has occurred. Turn off power then back on again. If problem persists, see the manual.” is displayed, the behavior of the print head holder has interrupted.
Check the following: Make sure print head holder motion is not impeded by protective material and tape for securing the print head holder, jammed paper, etc. Remove any impediment. When clearing an impediment to print head holder motion, be careful not to touch clear film (A), white belt (B), or tubes (C).
Cancel printing, turn off the machine. Then clear the jammed paper or protective material that is preventing the FINE cartridge holder from moving, and turn on the machine again. If the problem is not resolved, contact the service center.
Check the following: Make sure print head (cartridge) holder motion is not impeded by stabilizer, jammed paper, etc. Remove any impediment. Make sure the print heads (cartridges) are properly installed.
The password is set at the time of purchase. The password is the printer serial number. The printer serial number is printed on the sticker attached on the printer. It consists of 9 alphanumeric characters (four alphabets followed by five numbers).
With the printer powered on, select Setup . Select Device settings . Scroll to the bottom of the menu list and select Reset settings.
Ink may have run out (The lamp on the ink tank flashes). If printing is in progress, you are recommended to stop printing, replace the ink tank, and then print again.
#005. The recipient did not answer within 35 seconds. Confirm that the recipient`s machine is able to communicate, and then try again.
Check the following: Make sure print head holder motion is not impeded by tapes for securing the print head holderduring transportation, jammed paper, etc. Remove any impediment. Make sure the ink tanks are properly installed.
An ink tank(s) is not seated properly.
An ink tank(s) is not seated properly.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

CANON P200- ERROR 5100 PLEASE HELP!
ANSWER : Read this for solutions http://www.mytechtime.com/2011/10/canon-error-5100-how-to-fix.html

canon mx 700 error code 5100
ANSWER : The problem is how the hell do you put your hand in there to clean it? I have tried but could not clean it properly, hence my printer still has that error.

Canon Pixma MP150 Error Code 5100
ANSWER : Make sure you check that a copy of Gustave Holst’s journey to the stars cassette isn’t stuck in there! haha. That’s what my error 5100 was all about, I was getting ready to dismantle the thing after threatening it with a water boarding.

Re: Error 5100
ANSWER : To try and resolve the issue, please follow these steps:

Error Code 51.1 says Printer Error No Kidding.lol
ANSWER : Sometimes turning off and on will allow you to print a few pages. The error is a beam detect error. The only real fix is to replace the laser scanner unit. Could be a loose connector on the scanner or DC controller from the scanner. That’s unlikely. You could try the only other free fix which is to open the scanner assy. and clean all the mirrors inside. The dust could obstruct the laser beam enough to cause the detect error.

Printer Canon i560 Service Error?
ANSWER : 1 Turn off the printer.

error 5100
ANSWER : Here is one cause of that error https://www.youtube.com/watch?v=rJQVwwRxPv4

Canon MX922 Error Code 5100
ANSWER : You must first locate where the grinding sound came from. Re-install the printhead and cartridges because you might not inserted it properly. This might be also the cause of the error.