Epson Stylus DX4050

Try connecting the product to your router, access point, switch, or hub with another Ethernet cable. Try printing from another computer on the network to see if the problem persists. If network communication was interrupted while starting Epson Scan, exit Epson Scan, and restart it after a few seconds.

Remove the cartridges from your printer – switch your printer off. Using a piece of damp kitchen roll, gently wipe the copper plate on the cartridge. Allow the chips to air dry. Once the chips are completely dry, re-install the cartridges into your printer and switch the printer back on.

Check Cables and Printer USB Ports

Check all cable connections (including the power cord) on the printer side. If the printer does have power and you`ve properly connected the communication cable, but the printer is still not recognized, try switching to a different USB port on the PC.

Just above the circuit board on most printer cartridges, you`ll find a small button. You`ve seen these tiny buttons before on cell phones, phone chargers, etc. This is your reset button, and the only way to get in there is either with a paper clip or the tip of a pen (which will leave a tiny ink smudge on the button).

The most common reason a refilled ink cartridge does not work is that you didn`t reinstall the cartridge properly. Check the cartridge and make sure it is not dislodged or misaligned. If there is no visible sign of misinstallation, remove the cartridge and reinstall it.

Verify the ink cartridge(s) is inserted properly. Some cartridges snap in place, and if they are not inserted fully, the printer won`t print anything. If a lever is moved from its original position to allow for installation of ink cartridges, ensure it is returned to its original position.

Why is my Epson printer skipping lines when printing? Apart from a clogged printhead, one other potential culprit is the electronic connection of your cartridges with your printer. Try removing your cartridges from your printer, and then shutting your printer down.

What should I do? The ink cartridges may not have been installed using the correct procedure or they may not be seated correctly. Follow the instructions below to correctly install and reseat the ink cartridges. Turn on your product.

The printer will not operate if a black ink cartridge is expended or any cartridge is removed. If a color cartridge is expended, you may be able to continue printing temporarily with black ink. It`s best to always have extra cartridges on hand.

It is usually on the top right-hand side of your printer, near any digital display screen that the printer may have, and where the button used to turn the computer on and off is also located. Find the button marked Pause/Reset on the row of buttons on the control panel.

Chipped ink cartridges were originally introduced at the turn on the millennium. The reason behind their introduction was to ensure the printer recognised not only a cartridge made by the same manufacturer as the printer was attached but also how much ink remained inside.

Ensure that the supported settings are applied in the printer driver and click Print in Black to continue printing using Black Print Mode or Cancel Print to replace the expended cartridge.

Yes, you can reset the print settings to their original, default values. Press and hold down the Cancel button for 3 seconds. When the message to reset the printer to default settings appears, press OK to reset the print settings.

All cartridges must be installed with ink for printing and printer maintenance. For print quality, some ink remains in replaced cartridges. Designed for EPSON cartridges only: Other brands of ink supplies are not compatible and, if described as compatible, may not function properly or continuously.