Epson Action Laser 1500

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Small fragments of sticky label material commonly get torn off and stuck within your printer, collecting dust and causing a jam. Shut the printer off, get a flashlight, and try to see inside. Make sure no label fragments have jammed up your printer before proceeding.
Sometimes a paper jam error persists even though there is no jammed paper (false paper jam). Reset the printer, which might clear a false paper jam error, and then try to print again. With the printer turned on, disconnect the power cord from the printer. Unplug the power cord from the power source.
But for this specific issue, where the printer is reporting a paper jam even though no paper seems to be jammed, I`ve found that 90% of the time there`s one thing to blame: the guides on the paper tray. Any time your printer halts because of a paper jam, check the tray that holds the paper.
Loading paper that is stuck together, frayed, curled or bent can cause a jam. Overloading the paper tray, loading different thicknesses of paper in the tray or using paper that isn`t appropriate for your particular printer can all result in a jammed printer.
Low-quality paper leaves an accumulation of tiny paper bits often referred to as “paper dust” inside the machine. This “dust” is one of the top causes of paper jams. More dust means more jams. Besides jams, the dust also contributes to poor-quality prints and causes machine parts to wear at a faster rate.
Slide the paper all the way into the printer. The leading edge of the paper will stop at the Paper Drive Roller. Locate the Paper Sensor/OOPs sensor on the right side of the paper path. It can be seen from the top of the printer with the Top Cover open and has red, black, and blue wires attached to it.
A paper jam is when paper or other printed material gets stuck or lodged in a printer and cannot eject.
Some of the most common printer problems that most of us have experienced include paper jamming, slow printing, uneven printing, and wrong colour output. If you use your printer frequently, we know how annoying it can be to have persisting problems with the printer.
If you don`t run your printer that often, ink dries out, clogging your printheads. Even air bubbles in your ink cartridge can block the nozzle. But simple clogs can often be remedied by running a head cleaning cycle and nozzle check on your printer.
Creases and folds in the paper are normally due to one of the following conditions: The paper is not correctly loaded in the paper tray. You are printing on a special type of paper or other media. The paper has absorbed too much moisture from the surrounding air.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :

Epson Action Laser 1500

Epson R2400 printer paper jam reports all the time
ANSWER : I would like to second this question. I have the same issue with the media not being detected by the printer. The forwarding wheels squeak more than I would expect. I wonder where the sensor is that it uses to decide if there is paper or not. If I can figure it out I will post the saga here.

Read Full Q/A … :

Epson Action Laser 1500

Epson XP600 Paper Jam
ANSWER : hi Russ .did u find solution for ur problem?? i have the same problem ,how did u fix ur printer ..will be glad if u write me on email [email protected]

Read Full Q/A … :

Epson Action Laser 1500

Epson Stylus Photo T60 paper jam
ANSWER : paper jam

Read Full Q/A … :

Epson Action Laser 1500

Paper Jam and carriage jam code when nothing is jammed
ANSWER : Did you try cleaning the encoder strip that runs through the cartridge assy.? Use Window Cleaner on a paper towel. Also, check inside on the right. I’ve seen a lot of times where there is a folded up scrap of paper that stops the carriage from going all the way to the right.

Read Full Q/A … :

Epson Action Laser 1500

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :

Epson Action Laser 1500

Canon mx410 Paper jam message, but no paper jam?!
ANSWER : I have exactly the same problem, no answers 😳

Read Full Q/A … :

Epson Action Laser 1500

Paper Jam error but no paper jam
ANSWER : Obviously you didn’t get all the paper cleared out. There is a small scrap in the paper path causing the jam when the paper hits it. You can try clearing it out by inserting something stiff like a piece of file folder from the back of the printer into the paper path and pushing the offending piece out that way.

Read Full Q/A … :

Epson Action Laser 1500