Epson C-66 end of life ink pads

If an error message appears indicating the printer`s ink pads are nearing the end of their service life, contact Epson support to replace them. The message will be displayed at regular intervals until the ink pads are replaced.

If you receive a message that includes “Service is required,” the Maintenance Reset Utility was already used on your product. The Maintenance Reset Utility cannot be used again in order to ensure the proper operation of the printer and to minimize the risks of property damage.

Yes, you can reset the print settings to their original, default values. Press and hold down the Cancel button for 3 seconds. When the message to reset the printer to default settings appears, press OK to reset the print settings.

It is usually on the top right-hand side of your printer, near any digital display screen that the printer may have, and where the button used to turn the computer on and off is also located. Find the button marked Pause/Reset on the row of buttons on the control panel.

Just above the circuit board on most printer cartridges, you`ll find a small button. You`ve seen these tiny buttons before on cell phones, phone chargers, etc. This is your reset button, and the only way to get in there is either with a paper clip or the tip of a pen (which will leave a tiny ink smudge on the button).

Once you`ve removed the old waste ink pad, clean the area around the pad with a damp cloth or paper towel. Then, install the new waste ink pad and reassemble the printer. After replacing the waste ink pad, you`ll need to reset the waste ink counter to clear the “waste ink pad full” error message.

Re-Inkers are perfect for refilling your favorite ink pads or using on their own for watercolor, creating DIY Ink Pads, colorizing Texture Pastes & other mediums, and for Gel Plate printing techniques. In this video, you will see how simple to it is to add ink to dry ink pads with Re-Inkers.

If your inkpad is used up you will get a faint impression but if it is just dried out this will reconstitute the ink. I alternate using Staz-On Reinker and Denatured alcohol because if you get too much reinker on the pad it feels sticky. *You can also use denatured alcohol to revive dried up alcohol pens.

After replacing the waste ink pad, you`ll need to reset the waste ink counter to clear the “waste ink pad full” error message. To do this, you`ll need to enter your printer`s service mode and run a waste ink pad counter reset utility.

After replacing the waste ink pad, you`ll need to reset the waste ink counter to clear the “waste ink pad full” error message. To do this, you`ll need to enter your printer`s service mode and run a waste ink pad counter reset utility.

Buy EPSON Resetter Adjustment software program waste Inkpad error L 130 220 310 360 Online @ ₹299 from ShopClues.