Epson Stylus Color 880

How to Identify and Fix Common Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

Ink in a cartridge is low. You can continue printing, or check which cartridge is low and replace it.
The product is busy. Wait for the power light to stop flashing before turning off the product. If you just replaced an ink cartridge and the power light is still flashing after 3 minutes, the cartridge may be installed incorrectly.
Epson Stylus Series | Single Function Inkjet Printers | Printers | Epson® Official Support.
Ink may have run out (The lamp on the ink tank flashes). If printing is in progress, you are recommended to stop printing, replace the ink tank, and then print again.
The Power light blinks at a steady interval when the printer is processing a print job. If the Power light blinks fast, the ink cartridge door might be open, or the printer might be in an error state. If an error message displays on the computer screen, follow the on-screen messages to resolve the issue.
If the projector`s lamp shuts off, the Status light is flashing blue, and the Temp light is orange, the projector has overheated and shut off.
Epson`s DFX printer uses four sets of 9 pins for the fastest printing. 24-pin printer print sharper, more detailed text. Heavy-Duty printers are faster and handle thicker forms and larger workloads with ease.
All cartridges must be installed with ink for printing and printer maintenance. For print quality, some ink remains in replaced cartridges. Designed for EPSON cartridges only: Other brands of ink supplies are not compatible and, if described as compatible, may not function properly or continuously.
If your router is blinking orange, it is likely getting an upgrade and you should give it time before doing anything. However, if your internet is unavailable or slow, it can get stuck and the blinking will not stop. Resetting the router and the modem normally resolves the problem and restores the connection.
When you see a flashing light by data that means that a print job has been released to that printer but is still processing. This typically happens when someone is printing a larger file size job.
The ink is running low. Prepare a new ink cartridge.
🛑 That error indicates that the print-cartridge door is open or other errors exist. Did anything happen prior to the flashing light? ( paper jam, changed a toner) ✔️Check for a paper jam.
Meaning: the paper exit tray is closed / Paper jam. Solution: the paper is jammed. Remove the jammed paper, replace the paper correctly in the printer, and then press the Resume / Cancel button.
On a printer, an orange light usually indicates a problem related to printing activity. A blinking orange light can mean the printer is trying to print something, but is low on ink, out of paper, or there`s a paper jam.
Find the button marked Pause/Reset on the row of buttons on the control panel. Press and hold the button down for at least three seconds to clear the print job and reset your printer so you can start printing again. Try printing again. Repeat the process one time if you still experience printer errors.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

Epson Stylus Photo R200 – flashing red lights
ANSWER : The R800 will flash the ink and paper lights alternately when the ink pads are assumed to be full from extensive head cleaning. Sometimes, if not always, the head will lock into place on the right side above the ink head cleaning sponges that release ink to the lower ink pads.To correct the problem you need to clean the sponge area, I use cotton swabs. If the head is locked to need to release the carriage lock with a screwdriver. This will require removing the cover, but not necessarily the bottom of the unit.There is a 179 page service manual available for download for $16.50. There are free downloads of this manual, but usually are missing the 100 pages.You can remove the cover by:1. Remove the three screws on the rear housing (One to the left of the power plug, one on the opposite side and one in the lower middle bottom.2. Remove the three screws inside the upper housing (Just under the lid where the hinge is).3. Remove the screw under the left and right side in back below the vents.4. In the back pull the white ribbon closest to you out of the block, do not try to remove the block itself.5. Place a screwdriver into the slot both on the right and lift of the bottom corners on the back to release the hooks that hold the upper unit.6. Lastly, put a screwdriver into the notches on the bottom of the printer located in the front right and left, they are spring loaded.7. Remove cover.8. The head lock release screw is in the right side of the printer and is partially covered by the lower housing. I drilled a half inch hole into the side as to be able to insert a screwdriver. Turn the screw to the left and the head will rise out of the locked position. You only need to turn enough to release the head.9. Clean the sponges and any areas you see with excess ink.10. Place the cover on the unit enough to plug the white ribbon back in and turn the unit on.If the printer lights stop flashing then you are all set.

Read Full Q/A … :

Epson Stylus Color 880

Epson Stylus Photo R230 – flashing red lights fix
ANSWER : REDLIGHT

Read Full Q/A … :

Epson Stylus Color 880

Epson printer can't recognize Epson ink cartridge
ANSWER : Hi, my name is Jim.

Read Full Q/A … :

Epson Stylus Color 880

Epson R2400 flashing top two lights.
ANSWER : right..i had thisroblem and have fixed it..take rear cover off .looking from back..there is a small black sensor that had come loose.. reafix..and all working good

Read Full Q/A … :

Epson Stylus Color 880

Epson Artisan 835 print head cleaning question
ANSWER : I had the same problem. After reading the comments, I tried Liquid Wrench spray. 1st try got about sixty percent improvement. Tried again this time I let it set for about 10 min then did a head cleaning. Completely solved the problem. I am a little concerned about its use on plastic. So far so good.

Read Full Q/A … :

Epson Stylus Color 880

epson 7880 adjustment wizard
ANSWER : adjustment epson stylus pro 7880

Read Full Q/A … :

Epson Stylus Color 880

Epson XP600 Paper Jam
ANSWER : hi Russ .did u find solution for ur problem?? i have the same problem ,how did u fix ur printer ..will be glad if u write me on email [email protected]

Read Full Q/A … :

Epson Stylus Color 880

Epson, sudden cannot recognise cartridges error
ANSWER : Hi, I have exactly the same problem than you, I’ve been trying to solve it since 6 months. I have an Artisan PX730 WD, and the genuine cartridge can’t be recognized all together. And status monitor indicates same thing than you.

Read Full Q/A … :

Epson Stylus Color 880