How to Identify and Fix Common Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced technical support :
If an error message appears indicating the printer`s ink pads are nearing the end of their service life, contact Epson support to replace them. The message will be displayed at regular intervals until the ink pads are replaced.
After replacing the waste ink pad, you`ll need to reset the waste ink counter to clear the “waste ink pad full” error message. To do this, you`ll need to enter your printer`s service mode and run a waste ink pad counter reset utility.
There are a number of porous pads in the printer that collect, distribute, and contain ink that is not used on printed pages. Ink is collected by these pads during the initial setup of the product, during cleaning cycles, and when printing borderless photographs.
Buy EPSON Resetter Adjustment software program waste Inkpad error L 130 220 310 360 Online @ ₹299 from ShopClues.
Clean the contacts
If the contacts between the cartridge and the printer are dirty or clogged, there is a high chance that this can be the main cause for the ink to leak on the paper. To properly clean the contacts, open the printing machine and remove the ink cartridges and place them on a clean piece of paper.
Yes, you can reset the print settings to their original, default values. Press and hold down the Cancel button for 3 seconds. When the message to reset the printer to default settings appears, press OK to reset the print settings.
Chances are you will run out of ink (or the ink will dry out) before you need a replacement stamp! For self-inking stamps, the ink pad will last for up to 10,000 impressions before needing to be replaced. For pre-inked stamps, the ink pad will last for up to 50,000 impressions before needing to be replaced.
Spectrum Noir Opaque Pigment Inkpads are made from pigments rather than dye. Pigment molecules are bigger and need a thicker carrier. This means these inkpads are spongier and the ink is more sticky.
A fine and less-expensive alternative are dish sponges. Hot-glue a piece of upholstery foam (or a sponge) to the polystyrene foam tray or a dessert-sized plastic plate.
Press the tiny reset button located beside the chip and hold for 10 seconds. Depending on the brand and model of the cartridge, you may not need to hold the button for 10 seconds, but it won`t harm the cartridge so do it anyway just to be safe.
Note: When the maintenance box is full, you cannot print or clean the print head until it is replaced. However, you can perform operations that do not require ink, such as scanning.