Canon Pixma MP150
E-4 Error

How to Identify and Fix Common printer Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced technical support :

If the paper tears and you cannot remove the jammed paper from the paper output slot, open the paper output cover to remove the paper. Reload the paper, and press the Stop / Reset button on the machine. If you turned off the machine in step 1, all print jobs in the queue are canceled. Reprint if necessary.
Paper may be jammed if the rear cover is not closed completely. Push the rear cover until it is closed completely. If you cannot remove the paper or the paper tears inside the printer, or if the paper jam error continues after removing the paper, contact the service center.
Canon MG3150 – Error Codes

The led screen on the printer will flash a letter E and will then be followed by two numbers: Error E02 – The machine is out of paper or will not feed. Error E03 – Paper jam or output tray is closed. Error E04 – The Cartridge cannot be recognised.

The machine is unable to drain the water away

Should the error code E3 appears it is warning that the machine is not draining. You can easily fix this problem by removing any blockages from the drain pump situated at the front of the machine for easy access.

your pickup roller is dirty and the printer can`t grab a piece of paper. it will say paper jam when it does this. get a drop of dishsoap and clean the pickup roller of your printer with this. scrape at it with your fingernail to get the roller clean and wipe it off with a damp washcloth.
The way I solved it was to restart the print spooler. This will reset Window`s communication with the printer and Windows will no longer think the printer is out of paper. Problem solved.
E03 – The printer lid is open, or there is a paper jam.
Three flashes:Front Tray is closed/Paper is loaded into the Manual Feed Slot of the Front Tray/Paper jams. If the Front Tray is closed, open it. The printer resumes printing.
The F5 E3 alert indicates there is issue with the lid lock. Do not force the lid open, as permanent damage could occur. Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid.
C# enum PrinterStatus { Other = 1, Unknown, Idle, Printing, Warmup, Stopped Printing, Offline } So the result that you are getting (3) means it is Idling.
E03 – The printer lid is open, or there is a paper jam.
E > 3 > 2 appears

This screen appears when WPS setup was not completed within a certain time. For details on checking the wireless router settings, see the router manual or contact its manufacturer.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

My printer feeds through one piece of paper all the way and then a half piece of paper and stops. I pull out the paper to stop the paper jam and then it prints but sounds rough. After printing, it doesn't feed the paper all the way through.
ANSWER : And the first 2 sheets, the full and half sheet that go through first, are blank.

Read Full Q/A … :

Canon Pixma MP150

Paper Jam error but no paper jam
ANSWER : Obviously you didn’t get all the paper cleared out. There is a small scrap in the paper path causing the jam when the paper hits it. You can try clearing it out by inserting something stiff like a piece of file folder from the back of the printer into the paper path and pushing the offending piece out that way.

Read Full Q/A … :

Canon Pixma MP150

Paper Jam and carriage jam code when nothing is jammed
ANSWER : Did you try cleaning the encoder strip that runs through the cartridge assy.? Use Window Cleaner on a paper towel. Also, check inside on the right. I’ve seen a lot of times where there is a folded up scrap of paper that stops the carriage from going all the way to the right.

Read Full Q/A … :

Canon Pixma MP150

hp 8600 pro when power on, paper jam message appear but there is no paper jam in the tray
ANSWER : Hp 8180 Photosmart All In One code keeps says paper jam and carriage jam when neither are jammed. I followed all the recommended things to do. I live in Raleigh NC any place to take this or any suggestion.

Read Full Q/A … :

Canon Pixma MP150

Canon mx410 Paper jam message, but no paper jam?!
ANSWER : I have exactly the same problem, no answers 😳

Read Full Q/A … :

Canon Pixma MP150

Error Message "Paper out" when paper loaded
ANSWER : Check your paper tray settings as printer may be looking for paper from the manual feed tray on top of printer.

Read Full Q/A … :

Canon Pixma MP150

message error: ADF paper jam
ANSWER : There is a thin plastic arm that the paper pushes on. It is spring loaded. If it doesn’t return and unblock the sensor after the paper passes it, you get the paper jam warning. I’m guessing that is the spring you are referring to.

Read Full Q/A … :

Canon Pixma MP150

Error message to load paper and push OK, but not out of paper
ANSWER : I assist the binary options for a long time, and only half this past year I decided to alter the strategy for a better, she called for help Bing and he gave me this web site http://bestoptionstrategies.net .Now I focus on the suitable technique for themselves, and things gone up. I think everybody else faced with this particular problem. I believe my estimation will soon be helpful to you.

Read Full Q/A … :

Canon Pixma MP150